Whirlpool Cabrio WGD6400SW 7.0 Cu. Ft. Gas Dryer - White "dryer stops heating 5" Questions

stops-... Kenmore Dryer - heats & runs but stops mid-cycle. Asked Aug 30, 2006, 12:25 PM - 10 Answers .... Unfortunately it shuts off after a few minutes, I'll estimate about 5.After waiting about

dryer runs then stops after short periods (5-10 mins) my problem is that the dryer will start heat and tumble as usual, but after about 5-10 minutes depending upon the load will shut off. 10min to 30 ...

stops heating. I replaced the thermistor thinking that was the problem but it wasn't. If I try re starting the dryer after it has stopped heating the heating mechanism just glows and turns off

Dryer stops after 5 minutes Our Kenmore dryer runs for about 5 minutes then quits. After a few minutes we can start it again but it stops after about 5 minutes. Any suggestions to the problem? dryer ...

...stops. Dryer is hot, so I know the heating element is working. The timer keeps running until the time is up even though the dryer itself stops running. HELP!!!! Is there an easy fix or should I just ...

dryer stops and END is showed on display. I was having issues of dryer not producing enough heat, I have cleared the filter and cleaned the vent from outside also. So the dryer is now producing enough

...dryer not heating up when you start the heating cycle, it heats up for about 5 minutes and then it stops heating. LOOK TO THE HEATING THERMOSTAT IT HAS A SAFETY AND IT SWITCH OFF YOU HAVE TO RESET ...

...dryer heats normally. 4/5 times, the ignition element heats up, but then I hear a strange rattle/clicky sound, (which I assume is something related to the gas not starting to flow), and then the ...

...dryer comes on heats for 5 min then stops heating Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it ...

...stops. The dryer keeps tumbling, the air keeps blowing, just no heat. Any ideas? I would sure appreciate it! The thermostat that controls the heat has failed. Try one of the other settings on the ...