Goodman CLQ36AR49 Air Conditioner "run capacitor condenser unit" Questions

...condenser fan not running , check the capacitor for the fan to make sure it has not expanded also check if motor is getting proper voltage , is capacitor is good and motor has proper voltage supplied ...

condenser fan is running it's not an indication that the compressor is working. On a split system,there's a dual capacitor that serves the fan and the compressor. The capacitor has three terminals. 1.

...condenser runs for a long period of time it pops the capacitor. This is the starting component for the compressor and the fan outside. the coil needs to be cleaned with a non acid condenser cleaner. ...

...capacitor. A AC motor can run in both directions. The start capacitor is used to cause the current to lag behined the voltage which determines the direction the motor will turn. Its posible the start ...

...I check next? run capacitor. be sure you turn off the power to the outside unit. I bet its your run capacitor its the round silver object in the condenser. It has it MICRO FARAD RATING WRITTEN ON IT

unit fan has been working fine then last night noticed that fan wasn't running and was buzzing, I took a small twig and pushed on fan and it started, what could be causing this? Hello, usually

...for a good 10 mins then fans stop running and on/off button flashes Check your condenser unit is ful of dust? Clean it. And also weaken capacitor unit runs for 5 to 10 minutes only. Replace

run capacitor, etc. New 7.5 mfd 370 VAC Run Capacitor, but don't know how to hook wires back up from fan motor. Thanks ! Black wire goes to contactor. On your capacitor the brown wire goes on one side

run capacitor is popped. This happens when your condenser coil is very dirty. Even if your coil doesnt look dirty it still may be use condenser cleaner and replace dual capacitor. If this helps please

...condenser unit, in your 2 in one capacitor, there are three parts and one has four pins and other two has each two pins where you can clip the wire.Remove existing wires and replace same with new ...