...off when power is connected Check if the adaptor is working fine. Use a multimeter to check the voltage output from the adaptor. If the adaptor is working fine, please add a comment to the
...output Does your adaptor geting warmer when plugged to power outlet for some time (minutes)? If not, than there are two possible solutions: First (the easiest) thing is to check if both wires are not ...
Question about Toshiba Satellite Computers & Internet
...into the AC adaptor. The adapter might be faulty Check the adapter with multi-meter, the voltage reading should be slightly higher than the voltage output that is printed on the label on the
...output power. Is there an internal overload which may automatically reset or maybe a fuse? No, there are no reset button or fuse in these laptop adapters, they are a sealed unit. The lead/plug maybe ...
Question about Toshiba Satellite Computers & Internet
...check with known working outlet. If you have a multimeter you can the output of the AC adaptor. Also you can perform full power cycle and component discharge. Take the battery out and disconnect the ...
...output (not under load, i.e. unplugged). Little green light(s) on front DON'T light up. For a long time, the ON button has had to be pressed only on the front right corner and pressed rather hard to ...
check the output of your adaptor using any voltmeter. The voltage reading should be approximately close to the voltage rating as printed at the back of your laptop. If not, then its wiser to buy a new
Question about Toshiba Satellite Computers & Internet
...output. If you can, find a multimeter and check the plug end of the adaptor to make sure it's providing the same voltage as called for on the bottom of the Laptop (probably 16v). If there is much ...
Question about Toshiba Satellite Computers & Internet
output is). If you don't get any DC voltage (or too low), check the DC plug of the AC adapter. The inside of the plug should be + and the outside should be -. If you are getting voltage there, but not
...Check the output power of the adaptor if it is equal to the required output range. Usually you will be seeing that on the label of the power adaptor. If the power of the adaptor didn't match on the ...
1,438 questions posted
Usually answered in minutes!
1,650 Questions
1,252 Questions
1,162 Questions
1,043 Questions
438 Questions