...floor of the fridge, and poured hot water on the fan to unclog. However, I can't seem to remove the floor myself...there is a small piece in the front which I have to remove first (before sliding the ...
...floor of the fridge, and poured hot water on the fan to unclog. However, I can't seem to remove the floor myself...there is a small piece in the front which I have to remove first (before sliding the ...
Question about GE Refrigerators
...fan is located under the floor of the fridge 6 screws on the floor remove the floor remove foam . replace the motor. thanks the appliance doc Your fan is probably not the problem, most-likely the ...
unit or the floor of the house? Is the drippan in place or sitting on the floor? Also check the condenser fan motor. If this is all greek to you, you should probably call a factory authorized servicer
Question about GE Refrigerators
...fan moter is kaput. Remove the floor of the top compartment (carefully - it's plastic) and the insulation beneath. The floor is held by one screw, accessible when the front "Threshold" is pulled ...
Question about Refrigerators
...floor gets cold but the fan doesn't run in the freezer. So it's not getting my fridge cold Only choice is you will have is to remove the cover over the fan and see if something is blocking the fan ...
...floor not firm. - Cabinet not level. - Tubing in contact with cabinet, other tubing or other metal. - Drip tray vibrating. - Fan hitting another part or worn fan motor bearings. Unplug the unit and ...
Question about Samsung Refrigerators
...making noise again. Sounds like the noise is originating from about 3 feet up from the floor on the fridge side. There is nowhere on the back to unscrew to check. Sounds like the evaporator
...under. leaves white residue all over floor which has taken finish off wood floor. Sounds like you have a dirty condensor coil. Clean coil, clean fan blades and empty condensate pan. hope this
replace it? Are you certain the evap fan is bad? If it is, you can access it through the freezer section. Either the floor, or the back wall of the freezer. The associated screws should be easily seen
5 questions posted
Usually answered in minutes!
101 Questions
46 Questions
20 Questions
27 Questions
30 Questions