Honda 3000 Watt Portable Generator "getting gas oil" Questions

...oil? If you are getting gas there you need to perform a leakdown test on the cylinder to make sure the rings are not shot, and also the intake valve seal. A compression test will not reveal

...now This comes from gas getting from the carb when the engine is stopped. The carb will need a good cleaning. Kawasaki has vent tubes just to avoid this when air venting gets plugged. Just saying.

...gas and oil? Thanks! Bob Oil to gas. To obtain the correct oilmix ratio, pour 3.2 ounces of 2--cycle synthetic oil into one gallon of fresh gas. Plug gap 0.025 inch (0.6 mm) Or you can get the manual ...

oil and gas, I could not get it to start or run. I sprayed gas into carburator throat and it started but would not run. yes there is oil, all wires are connected, opened fuel valve. Choked it but will

oil smells like gas and it want start Your carburetor needle is stuck and gas is getting into the engine. You need to repair the carb and change the oil.

homelite adjust carb getting gas spark plug is fireing but will not start check the gas shut off is on. Check oil, some have a safety shut off on oil .Clean filters and carb

...gas. Carb getting fuel. Sprayed ether into air filter, starts for 3 or 4 seconds and dies. Will not continue running. Any idea. Generator only 2 years old. the worst thing for generator and ...

...gas, plug, everything imaginable.... won't start! Coleman, Powermate 12 HP 6000W generator I hate to ask,is there oil in it?There's a shut off for low oil level,it's to save the engine from starving ...

Gas in oil I have a Honda EM1800 Generator, I could start the engine for a few seconds and then the motor would spit a milky color substance through the Carb. I checked the float on the Carburetor no ...

...getting past the rings, valve stem seals are worn " if seals should only smoke briefly after start and go away " or oil in the gas...first check for oil in the gas..Should show on the dip stick..if ...