...auto throttle off. engaging auto throttle shuts down unit. in past months, pluging in a cord would shut down unit. That is with no tool in use, just plugging into the receptacle. Hi. There are 2 ...
...auto throttle were cut at the The wires to the auto throttle were cut. No manual throttle control on unit. i have the same problem did you find a solution? anyone know what this is used for min has ...
Question about Honda Electrical Supplies
...auto throttle is switched on making me run full throttle at all times. Cause? Solution? is there a load of at least 30% of rated generator load connected and proved working ? if not the the Auto ...
Question about Honda Electrical Supplies
...auto-throttle control unit is faulty. Unit runs at reduced RPM even when under load. Seems to run at full RPM when turngin auto-throttle off. from your description and what you do , the problem is in ...
throttle assembly. You could also try tracing the wire from the auto idle switch backwards. This may just be stuck in the idle position by corrosion. especially if you live in a humid area or one near
Question about Honda Electrical Supplies
...throttle position. You may have to fiddle with the adjustment a little until you find the right spot. Tighten the jam nut back down and you're good to go. Carl Off load, if you leave it on auto idle ...
...is blown again. Any ideas? The auto speed control is failed. Keep it manual and see how it does...It will run at full throttle even when no load is running. Then fix the throttle control when
Question about Electrical Supplies
Honda EX 3300 power generator will not stay on in auto throttle mode. It becomes difficult to restart after being turned on for a while. Check the fuel filter and the spark plug.
...auto-load sensing button is off but not be like its choking or sputtering. Anyhow if it is idling roughly, I can only come up with 2 possible causes, if I may suggest: 1.) the cable that gradually ...
The auto throttle doesn't kick on, runs full boar constantly This is likely a govenor problem. Some of these problems are caused by a lost spring on the govenor linkage.
182 questions posted
Usually answered in minutes!
50 Questions
1 Questions
15 Questions