Jura Capresso Impressa E75 Espresso & Coffee Maker "tray going back" Questions

...tray to go back in. There is a metal blade that is down in the tray area that I dont seem to remember being there. This is because the machine didn't run the full cyce or the tray was removed while ...

...tray, for some odd reason, was not going back in. I simply tried it without the top part - that receives the grounds - and was finally able to get it in. I pulled it back out and found some grounds ...

going fully back into the machine or being pulled out. The tray and grounds basket was simply stuck in between! I thought my life was over as the machine was our wedding gift from my mother-in-law! So

...Container as it is the component that usually catches against the scraper. The machine should then cycle and revert to its normal position where it will be possible to put the complete tray back

..."Tooth Pick" simply press the switch inward (to the right) and hold till the machine cycles the Levcer / Flap up and out of the way.! Put your tray and grounds container back in and begin brewing!! ...

...tray back. The coffee machine started the cleaning process again and it finished. I think the problem was emptying the dirty water in the tray through the back instead of the front; something must ...

...drip tray/ dump box out while the brew unit was still active. Switch off the machine and insert the drip tray without the dump box. Turn the machine back on and the brew unit should re align

...in and turn on again. Most times the malfunction clears and the grounds end up in the liquid catcher tray. I then remove the tray and put the container for the grounds back in and continue normal

tray to go back in after emptying grounds Unplug machine, wait a minute or so, plug back in while pushing the tray in as far as possible. It makes some noise as it resets and moves parts around inside