Jura Capresso Impressa Z5 Espresso/Coffee Maker "tray back machine" Questions

...tray is back in place, but then when the tray is put back into position the tray missing message returns. Have cleaned the machine and cannot work out how the machine senses the tray is in place. ...

...tray to go back in. There is a metal blade that is down in the tray area that I dont seem to remember being there. This is because the machine didn't run the full cyce or the tray was removed while ...

...tray back without the grounds container (b/c it is higher; that's what can't get past the flap). Make a cup of coffee, letting the grounds fall into the tray. Normally, after you do that, the machine ...

...back of the machine Place the tray into the coffee maker without the basket and run one cup of coffee Replace the basket into the tray. It will now fit. I emptied the coffee tray (3 parts) and tried ...

...back of the tray. Be sure they are cleans as well as the plastic space between them. Then using compressed air clean where the contacts enter the machine in the rear. Usually there is moisture back ...

tray to go back in after emptying grounds Unplug machine, wait a minute or so, plug back in while pushing the tray in as far as possible. It makes some noise as it resets and moves parts around inside

...fix was to just finish the cleaning cycle without the tray in and at the end the flap was back in place and we could fit the tray in again. I just used my air compressor inside and that was it fixed

...tray will not go back in with the grounds basket installed. Seems as thought the mechanism is jammed out of place. I have cleaned out the tray and vacuum cleaned the inside of the machine to no avail ...

...tray back in to the machine with the paper towel on it and then pull it back out. The paper towel will clean the slot inside the machine. According to the Instruction Manual section 21 page 68 when ...