...clock. 5. Push the crown back into its normal position. Set the digiatl time and date in your tie zone, and your analog hands should match the digital read-out. If the zeroing of the hands is not the ...
clock (midnight) position using "A" and "C" buttons. At the same time, observe the synchronized 24 hour hand (small dial to the left of the main dial), to insure that it also moves to point to "24". 4
...or if both are wrong. If it's just that the hour is wrong, you need to set the time zone. Atomic clocks and watches have a "zero" position. Your manual should tell you how to "zero" the watch and ...
...clock but it's not actually turning on when I push the side button in? It's a new watch direct from Timex so I don't understand what I'm doing wrong... there only seems to be two modes - pushed out ...
...clock. Your watches' second pass is at midday instead of midnight, so to make it operate correctly, you need to wind it on 12 hours. The date will then change at midnight. You have your watch set ...
...mine to pickup the time sync signal since a few days before the time change. The day to change your clocks for DST in California was changed. You need to set it to ON in the fall and to OFF in the ...
...clock with the wrong time zone. The Casio site has access to manuals, but it does not react to my entering my watch number, so I guess that manual is not available. Does anyone know where to find the ...
displaying the basic reset display, flashing 12HR. If not, the battery is not seated properly. Remove the battery and begin again. Check to make sure you have a new fresh battery. Otherwise, carefully
63 questions posted
Usually answered in minutes!
12 Questions
11 Questions
16 Questions
3 Questions