...dishwasher sitting at hot temp (174), constant steaming from unit, bottom rinse wand spinning & humming non stop? We reset prior to problem because it was not rising to temp (sitting at 106-112) ...
...place to protect the Control Unit from overheating cause by to high of an amp draw from the motor, the heating element, or a dead short in one of the solenoids. Replace the thermal fuse, which is ...
...dishwasher, you have a problem. Some of the most common reasons include that the drain hose isn?t working properly, the drain pump isn?t working correctly, or possibly there is a plumbing problem in ...
...dishwasher. You`ll need to confirm it does or doesn`t exist because it IS necessary for long term well being of the machine...which leads to the other possible problem. If the loop was never put in ...
...dishwasher and test. Note: You may have to let the dishwasher run a few minutes before it reaches the next water fill cycle. Internal filters Every dishwasher has some type of filter to keep large ...
...place an ammeter on the gray/black wire it should draw 11 amps during the wash cycle...after it fills and the flow switch indicates it has adequate water to engage the heater. i.e. **My Opinion - if ...
...place by screws directly into the counter top. You may have to lower it to get it out. The front feet turn with a wrench to lower. Turn off the water supply. Run the unit again until you get to the ...
24 questions posted
Usually answered in minutes!
480 Questions
217 Questions
151 Questions
124 Questions
109 Questions