KitchenAid K45SS Classic Stand Mixer "top side screws" Questions

...the mixing head. Tighten the four screws ( item 14 - 2 on each side) and the top will no longer be loose. ...

...screws (two on each side) holding on the top cover for the mixer. Remove the four screws and then lift off the top cover and you'll see the motor, circuit board and gear box that operate the

...side, if not you may have a new trim band (Generic type) put on during the reconditioning to pretty it up. In any event in the back of the mixer is an end cover, at the top is a small Phillips head ...

...can be removed. Now you will see two more phillips head screws on each side under where the band had been. Remove them and the top of the motor will lift off. good luck with it. please rate my

top screws is 8 full turns in from being not even in the hole (both sides) and on speed 1 the bottom screw does not even touch that step in the flat rod that activates the switch and moves the control

...side yoke slide to release the yoke. You will need to lift the yoke to reach some of them. If you have some wood place it under the yoke and over the legs to protect the paint. On top of the yoke are ...

...side of the mixer base there is a hole that goes right through. There is a metal rod sticking out of this which I noticed is sticking out further than normal. I think the top of the mixer is dropping ...

...top part of the mixer has about 1/2 inch play and must be lifted in order to put in lock position It sounds like the bar that the head hinges on has come out. It is located on the base and should be ...

...that didnt work then turn screw see if it helps . if thats not it check the brushes theres 2 of them one on each side of the top body of the mixer. if there shorter then a half inch replace

...top wobbles causing this "pin" to work it's way loose out the side. This has progressed to now the beaters scrapping the bottom of the mixing bowl when in use. There is no wear on the paint between ...