KitchenAid K45SS Classic Stand Mixer "replace speed control plate" Questions

...Make sure the lever is moving the plate in and out. If yes then I would replace the small PCB above the control plate, that is the electronic part of the speed control and not worth very much at

...replace the speed control phase board. With the line cord disconnected, pull the t-bar contacts to open and insert a piece of paper between them so they cannot close. Reapply power-the mixer should ...

...speed control plate, Remove the trim and end cover on the mixer, the first thing you should see is the speed control plate, this has 3 screws on it, try adjusting the top two screws 1/4 turn, this ...

...replace the speed control plate Take the back cover off, remove the wires. Unclip the spring from the bottom of the plate, don't let it fly back inside the housing. Unlock the 2 screws at the top and ...

...speed control plate screws,there are 3 screws on this plate, one at the bottom two at the top, see if adjusting the top screws slows your mixer down. Next check the wiring of the mixer, Insure ...

...speed control is in Off position. The engine doesn't work in any other speed setting i.e. stir to 10. With the control plate's top screws turned completely clockwise, Off is truly Off. A half turn ...

have no broken wires to the speed control plate. Check that the switch on the speed control plate is functioning. If all that tests OK I'd replace the phase board, it's worth not much and worth a shot

...very top. It has 4 wires coming off it. They are not at all expensive to buy and easy to replace. One screw holds it on and just the 4 wires to clip off the terminals on the black speed control

...speed control plate. It should move freely in and out. If not then check for binding and/or loose screws. If all the above is OK then the problem is most likely the phase control board item #30. It ...