Question about Microwave Ovens
start right away, now it runs for a few seconds then stops but the food is still being heated. The fan, a door switch, or control board relay may be causing the fan issue. Running the MW without a fan
Question about GE Microwave Ovens
...start, I can get it to run, but not often. Any help would be greatly appreciated. Obvious thing is to try plugging in a different receptacle to verify if it might be bad wiring in your kitchen. Make ...
Question about Magic Chef Microwave Ovens
...the fuse and when i plug in it pops and blows the use. Any suggestions? There are a lot of possible causes, but I'd look at the door switches first, and the wiring connectors to them. Make sure the ...
Microwave won't shut off The microwave will not shut off. There is no display and no way for me to clear or enter anything on the control panel. When I open the door, the microwave stops, but as soon ...
Question about Sunbeam Microwave Ovens
start. What is going on? There could be a problem with your microwaves switchboard.Or the wiring connection is not good and causes it to heat up and causes the fuse to trip and then has the power shut
When using the oven and the timer sounds that cooking is completed and I open the door to take the food out the oven immediately starts going again - it does not shut off. Once the door is opened the ...
Question about Whirlpool Microwave Ovens
Microwave shuts off after three seconds....but only sometimes I have a Whirlpool wmh1162xvq-2 over the range microwave. Recently it started turning off after only a few seconds of running. This only ...
Question about Emerson Microwave Ovens
...sensor that will cause the microwave to shut down. Unplug it from the wall outlet. Leave the door open and after a while, about 15 or 20 minutes, plug it back in and it should start working
...cooling the oven therefore it will shut down when it reaches a certain temperature. This could be caused by a supply fault to the fan or the fan motor, either way it would need to be tested by a ...
...open position at the top of the unit. Mechanical misalignment of the pivoting fan panel seems to cause a motor overdraw, or something similar, which shuts down the unit. I've found that I can ...
51 questions posted
Usually answered in minutes!
258 Questions
74 Questions
77 Questions
63 Questions
47 Questions