Troy-Bilt TROY-BUILT 91215 - TROY-BUILT 20416 Pressure Washer 5HP Gas 3000 PSI Gas Powered "removing engines" Questions

...removing the carb. You may have to remove the bolts that hold the engine to the cart and turn the engine sideways to clear the way to slide the carburetor off. It sucks but the manufacturer of the ...

What kind of oil do you put into a Excell pressure (exh2425) washer pump? Do you use the same as engine oil (30 w)? Pressure washer oil I took this picture of my power washer so it's easy to explain ...

i have unionpower up-150 washer it wpnt start stood for a while hi not sure what engine is on this unit but I assume it is a honda engine or copy of on your unit as that looks like a standard engine ...

...suspect more serious problems.  If the rod is siezed due to low oil, it can be replace by removing the sump.  No big deal and could be nice project.  Before you take anything ...

overfilled the oil and black smoke came. Can't startt now what i need to do hi there pauly46 here remove plug, pull engine over to remove oil from combustion chamber , clean plug, refit, remove ...

...pressure still the same what more can I do?? Dear Sir, I understand that the engine seem jammed. Removing the spark plug was a good idea. This indicates that the engine cannot turn. The only

what oil is used when changing the old oil Pressure washer oil I took this picture of my power washer so it's easy to explain the oil. The oil is different for engine and pump. The pump oil is 20 or ...

...clean the fuel system. If engine doesn't start check for spark either using a spark tester or removing the spark plug and holding plug against the engine frame and pulling starter rope if spark ...

My 24o0 pressure washer pump has failed. Unbolted My Karcher 2400 pressure washer pump has failed. Unbolted the pump but it won't come off from the engine. Spins but acts like it is key locked. WHat ...

...problem If it is a vertical shaft engine then it is most likely the crankshaft seal. That requires removing the engine from the frame and removing the pump from the motor to replace the seal. If it ...