Question about Water Heaters
30 gallon electric water heater model #71-30D serial #RH 0701230647 take? Take element to hardware store or home center and they will match up the same wattage that is printed on end of element http:/
...30 gal short water heater. It only seems to put out about 10 gallons of hot water before it starts going cold,any suggestions...... I am assuming that everything was fine and then all of the sudden ...
...elements stop heating) Using a 5 gallon bucket, start drawing hot water from bath tub, while measuring temperature from faucet. You should get 60% of the tanks capacity before the temperature drops 5 ...
...elements are low-watt-density, so element does not burn out as easily since heating is spread across more surface area. But recovery remains 16 gallon per hour. 20 amp breaker and 12 gauge wire: max ...
elements ohm at 12.5 For images and product information For manual You checked ohms, did you check for 240V across lower element when lower element is turned on? Energy smart electric water heater has
...30 gallon model # 81sv-30d water heater with upper and lower watages 3500. how do i know what size heating element i need? Look on label on side of tank. Wattage of tank will be element wattage. This ...
Question about Rheem Water Heaters
30 amp breaker, then install two 5500 watt elements. This will not work if you have smaller 12 gauge wire and 20 amp breaker.Watt rating appears on side of each element.http://waterheatertimer.org/How
...30 minutes wintertime. So incoming water temperature is a factor. If your water heater is not full of water before turning on electricity, then elements will burn out. Also the ECO might be tripped ...
Question about Rheem Water Heaters
...rheem 40 gallon electric water heater model #71-30D serial #RH 0701230647 take? Standard generic element from hardware store http://waterheatertimer.org/How-to-replace-water-heater-element.html ...
30 minutes and doing troubleshoot before replacing any parts. Buy cheap multimeter from home center. When testing voltage, rotate multimeter dial to 240-250-277 VAC When testing elements or continuity
359 questions posted
Usually answered in minutes!
250 Questions
267 Questions
222 Questions
190 Questions
96 Questions