2011 Melbourne Jayco Circuit Brakers

Not much on it. Contact Jayco direct in the morning.

https://www.google.com/search?q=2014+jayco+pinnacle+36kpts+water+diagram

..

Question moved from Cars and Trucks to one of the Jayco RV categories. There are 4 for 2015.

There are screws inside the unit. Check out the videos.

https://www.google.com/search?q=remove+AC+wall+unit+from+2015+Jayco+RV

.and also

https://www.google.com/search?q=AC+wall+unit+from+2015+Jayco+RV

...

Question moved to one of the Jayco categories.

Manual and some videos

https://www.google.com/search?q=Jayco+Prestige+operate+front+blinds

..

notify jayco -rv dealer -rv shop or online search

Contact an authorized Jayco Dealer or Jayco RV directly:
Contact Us Family RV Jayco Inc

Contact your local authorized Jayco retailer or Jayco directly here: Contact Us Family RV Jayco Inc

Contact your local service center directly or online here:

Contact Us Family RV Jayco Inc

120-
VOLT
AC
SYSTEM
The following electrical components (if so equipped) will only operate when your
RV is connected to shore power: 120 to
12-volt power converter, air conditioner,
120-volt refrigerator, microwave oven, television(s), fireplace and appliances
plugged into convenience receptacles.

SECTION 6 - ELECTRICAL SYSTEM JAYCO TOWABLE
6-2
120-
VOLT
CIRCUIT
BREAKERS
The 120-volt AC circuit breakers located in
side the main load center protect all
120-volt wiring and components in the RV fr
om circuit overloads and short circuits.
Should a circuit overload or short circui
t occur the circuit breaker protecting the
affected circuit will "trip" preventing the flow of electricity through that circuit.
If a circuit breaker trips, shut "off"
the appliance on that circuit (i.e., power
converter etc.) and allow the circuit breaker to cool down for a brief period of time.
After the cooling down period, reset the circuit breaker by moving its lever "off" and
then back to the "on" position. If the circuit breaker re-trips or frequently trips,
contact your dealer to have the electrical problem diagnosed and repaired.
A circuit breaker identification label is permanently attached to the inside surface
of the 120-volt load center.
Maintenance and Replacement
At the beginning of camping season, inspect the circuit breakers and replace as
needed. Test by turning each circuit breaker "off" and back "on". Circuit breakers
are wearable parts and must be replaced
as needed, as part of your RV
maintenance. If you have any questions, consult your dealer.
Please contact your dealer for repair assistance when replacing circuit breakers.
CONVERTER
The power converter converts 120-volt AC power to useable 12-volt DC power
when the shore power cord is connected to an external power source.
The converter has a built-in protective thermal breaker that will shut it down should
overheating occur. Overheating can be
caused by operating the converter above
its maximum power output for an extended period of time, or by an obstruction to
its ventilation air flow. To reduce converter heat build keep unnecessary 12-volt
lights and motors turned "off"
.
Keep the converter cooling fins and fan clear of
obstructions.
Inspection and maintenance
If the 12-volt power converter is not working (auxiliary battery not being charged)
check the reverse polarity fuse(s) in the converter fuse panel.
There are no
customer serviceable parts inside the converter case and the
manufacturer's warranty will be void if
the case has been removed
. If you
have further concerns contact your dealer.

http://easyrvwindows.com/rv-window-installation.html

Remove the screen/washer at the city valve and you see a small stem in center of valve, that's the plunger (check valve ) . Use a pair of needle-nose pliers if necessary to push it in ( it should have spring behind it) slightly and make sure it is centered in the hole, then just pull on it slightly to seat it. Now try pump. If it won't seat properly and water still shoots out, it's probably defective and needs changing. Perhaps whoever winterized it forgot to push that in after pumping antifreeze through system, which results in water trapped in valve, thus freezes and breaks apart inside. If your stuck, screw a plug the right size into the city water fitting. Short piece of old garden hose with male end & plug (old bolt or anything proper diameter) and small hose clamp in other end will work for temporary use even.