Were do i find the indacator relay to replace it

is the Check Engine Light on? many newer cars will illuminate several lights and disable systems if the ECU records a DTC.

Has the battery been tested?

You need to check the connections in the instrument panel.

do you have halogen or hid lights sounds like a ballast or ground issue more info!!

Hi good day

Try to clean the catridge of your printer. thats why it indacate as low ink sometimes the ink level indacator is not accurate.. for better sulotion try to your printer in other unit of pc in can help you to know if your program is not malfunctioning. i hope you to solve your problem.

this could be a few things. first and simplest is the fan switch on. next with the system switch off check for 24 vac from g to common (usally labeled c) if you have 24vac at these termainls with the fan in auto and the system off you have a bad stat or a shorted wire. the other thing it could be is a heat relay sticking closed. does the fan slow down when the outside unit shuts off is the air comming out of the vent seem alittle warm. either or both of these would indacate a stuck heat relay (more commnly called a sequencer)

If your turn signals are coming on and they are not blinking, the most common cause of that symptom is the turn signal relay has failed. If the front and rear turn signals are not both coming on with the TS switch, they will never flash. The flasher relay needs enough amp draw to make it function. Replace the TS relay.

its low on freion thats why it cuts on and off

Your switch is sticking. Get a can of lubricant (WD-40 or the like) and thorougly spray the switches as well as inside the doors including lock mechanisms. You may have to open and close the doors several times to get the light to go out. Best of luck.
Greg