My pulsar220f is getting engine heat very soon how to send me sollution

Copied picture from the internet:

http://lookbook.nu/look/8203507-Shine-My-Feet

Error Code: P0154
Description:
Heated Oxygen Sensor (HO2S) 1 , Bank 2 - No Activity Detected
Problem areas:
- Wiring.
- Open circuit in signal wire, between Heated Oxygen sensor 1, Bank 2 and ECM. (Must check and confirm)
- Heated oxygen sensor (HO2S).
- Engine control module (ECM).

I'm assuming your talking about the batteries. You can purchase more batteries and put it in parallel to your existing batteries. it will give you longer run time.

no sollution at solution coming at soon wait

P0044 - HO2S Heater Control Circuit High (Bank 1 Sensor 3)

The P0044 is set when the ECM detects an excessively high voltage through the heated oxygen sensor heater circuit

Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.

Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 3 circuit open shorted to ground
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 3 circuit poor electrical connection
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 3 circuit
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 3 circuit fuse
- Faulty Engine Control Module (ECM)

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.



Hope helps (remember to rate this answer).

You may have a faulty gauge sending unit. Or the thermostat may not be closing soon enough for the engine to heat up. With a OBD II scan tool you should be able to monitor the engine temperature. Most parts stores will scan your vehicle's computer for free.

Hi,
Check your heating element..
A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

Dishwasher Maintenance

heatman101

Asker's Testimonial " explanation very clear. will give it a go and seehow simple it was. thanks Ronnie " - ronnieshomes

check the 2 cold vents see if they r blowing out less on high than the other. check ur vent hoses between the vents it might be disconnected and only sucking in cold air. that will get u started on a sollution. some vehicles vent hoses tend to run out side the fire wall in the engine compartment.

it is because the map packs usually dont show up because many people dont buy map pak like me and the map packs are more fore zonbies. CAN U TELL ME UR GAMERTAG? THIS IS MY Desaihi5