SOURCE: Tires for yamaha vstar 650
i have a dunlop on front and metzler on rear of my 650 star and its fine
SOURCE: 1999 Yamaha Vstar 650 Custom ...makes clicking noise when trned
i use a jump box on mine most weekends when i wanna take it out, i hook the red to battery and black onto my exhaust and it fires right up no problem. is the clicking noise coming from the fuel pump behind the ignition? it should click for a few seconds then stop. if it stays on then you are not getting enough fuel outta the tank, change the fuel filter and if bike had been stored for winter get a good fuel system cleaner, additive type. if in USA get Berrymans B12, double dose get bike to run hopefully let it stand overnight and all should be fine. fingers crossed. if is is clicking from somewhere else like starter or a relay by the battery, check all the ground terminals you can find
http://www.carlsalter.com/aaman/Yamaha_VSTAR_650_MAIN_MAN.pdf
thats a link for a free pdf service manual
my 99 v star
SOURCE: Rejetting a Yamaha Vstar 650
No it will not. You probably don't NEED to rejet at all. If the manufacturer suggests it for your bike and pipe combination I would follow their advice. If they do not suggest it I would use a dyno to get the best performance from your new setup. Keep in mine your new exhaust only lowers the back pressure. You haven't changed the intake parameters at all as far as airflow. So any additional air going into the cylinders due to your new exhaust will only be because of the reduced volume in the cylinder while the intake valve is open. This is a rather small amount, so don't get all crazy and jump several jet sizes at once.
SOURCE: 2007 650 yamaha vstar popping through the rear cylinder exhaust
First off did you buy it new? Second has it gone through its break in tune up yet?Did you do the re jeting? My guess is it was re jeted wrong & neeeds to be re jeted again or could also need more air(upgraded air kit) or a tfi or power comand fuel mod.My bike also poped untill I did the air & fuel upgrades & them upgrades will also give you a much needed house power needed for this rig.
Bring it to a shop & have it looked at.......
Good luck
SOURCE: I have a yamaha vstar xvs 650. there is a noise in
Try tapping the spokes, if one is loose you'll know it. Check the oil in your driveshaft head.
Picking the Star up to get the wheel off the ground is a chore but you (and a few strong friends) might have to do just that to investigate the noise more fully. With the wheel in the air you can wiggle and listen.
BTW, are you sure it isn't the rear caliper?
373 views
Usually answered in minutes!
×