I need a left turn signal lens, any idea on where I can find one?

Get the left signal to flash fast then walk around the car to see which light isn't flashing then change the bulb or socket if they all appear to be flashing (front and rear) turn on the right turn signal then look into the front and rear lens and count the number of bulbs flashing, now do the same thing on the left. Many times there's more than 1 bulb in each lamp. I hope this helps. Take care.

Does the recording show a black image or no video signal? If the image is black, is the cover being left on the lens? Is the lens broken or something perhaps internally obstructing its view. If there isn't a video signal, and it reads as only an audio file than have you checked you've set the camcorder to the correct setting so the video camera portion is turned on?

remove rear left lens and install new turn signal bulb.

What you speak of as to the left blinker doesn't flash, yet the instrument cluster shows the green arrow (to the left), and yet that and the left turn signal lights do not flash, appears to be a simple burned out bulb. If one of your left turn signal bulbs are burnt out, then the #552 Flasher Unit in your fuse box is NOT the cause. It's the "Amperage" not being correct to the flasher unit. Place the parking brake on and start your vehicle. Put the left turn signal on and check to see ALL the bulbs are illuminated for the left turn signal. If you find one bulb that is not illuminated, then replace the bulb. It should be an 1157 bulb, but in the front it could be a 1157 Amber bulb dependent on whether your turn signal lens is clear or yellow.

If you still have difficulty finding the dead bulb, turn on the right turn signal and see which bulbs are illuminated and this will give you an idea as to which bulb on the left side isn't working, or turn on your Emergency Flashers which will turn on both the left and right side lamps and see which bulb is not lit up.

I hope this Helps,

~00 Buck~

"Still living on the Right Side of Dirt..."

Hi! The left turn signal bulb may be faulty and may need replacement. Just open the hood, pull out the corner lens and replace the bulb. HOpe this helps and have a good one!

Signal and Marker Lights REMOVAL & INSTALLATION Front Turn Signal and Parking Lights

1. Disconnect the negative battery cable.
2. At the rear of the front bumper, turn the bulb socket 1⁄4 turn and remove the socket from the parking brake housing.
3. Remove the bulb from the socket; if necessary, replace the bulb.
4. If lens replacement is necessary, remove the retaining bolts and remove the lens from the bumper.
5. To install, reverse the removal procedures. Check the turn signal/parking light operations.

Fig. 1: Common front turn signal/parking light mounting


Fig. 2: Twist and remove the bulb socket from the back of the turn signal/parking light lens


Fig. 3: If lens removal is necessary, loosen and remove the retaining bolts

Check this info KJ-2002-Liberty-Service-Manual-PDF-Secc-08-Electrical-Systems ( 8L-1 page 165 and next) about headlight remove instructions.

Good luck!!!

first just because a bulb looks good doesnt mean it is couple of peices of wire and a battery is all you need to test the bulbs secound thing the turn signal cancel works on the amount of flashes regardless of which side is on note:any bulb thats bad none on that side will work

Did the new lens come with new sockets? If not damage may have occured there that you cant see. only other possibilty is wiring damage in the rear that may be hard to see. The condition you describe is simple "backfeeding" if you look hard enough youll either find bad sockets or damaged wires close to the lens that took the hit. Hope this helped. Thanks

reach screwdriver down between headlight and marker to releace clip, pull forward.