The Dyna battery can be removed by:
1. Remove the seat.
2. Remove negative connection at frame, and positive connection at battery.
3. Remove the lower rear bolt. (left side of battery box at frame upright)
4. Remove the upper rear bolt, and swing down the battery box.
5. Remove the top cover, nad side cover.
6. Lift battery out, and remove negative cable from battery.
SOURCE: how do you remove battery from dyna low rider
I have an early model and I think they're still the same in that area. There are two bolts on the right side of the battery support. Loosen these two bolts and the battery will drop down a bit allowing you to remove the battery top cover and front cover.
SOURCE: Battery removal 2002 dyna super
Just inside the frame from the battery, there's a "jackbolt" that raises and lowers the battery tray. Turning the bolt counterclockwise lowers the battery tray and vice versa. You must loosen two bolts on the right side of the frame just behind the battery box between the battery box and the rear fender. Once the battery is lowered, you'll be able to get the top cover off and disconnect the battery cables. Disconnect the negative first when taking the battery out. Connect the negative last when installing the battery.
Good Luck
steve
SOURCE: i need to remove battery
On the older models this is how you remove the battery. I doubt Harley has changed much but if they did, this may help.
Remove the seat. Just behind the battery between it and the rear fender on the right side of the bike, there are two bolts. Loosen the bolts but don't take them out. Look inside the frame behind the battery and you'll see a "jack bolt". Turning the bolt counterclockwise will lower the battery tray allowing you to get the top cover and surrounding cover off. Then you can get to the battery connections easily.
I hope this helps.
Ride Safe
Steve
1,587 views
Usually answered in minutes!
×