Can not figure out my wiring on a 1976 yamaha TT500 for the points, coil, and magneto
SOURCE: tt500 wireing
I have edited the picture to show what to do.
Note:You may need to try each of the 2 wires from the generator(try one and if it doesn't run or run right,try the other wire,Since the energize at different times)
SOURCE: xt 500 has weak spark(flywheel
It sounds to me that you have done most all of what is needed. Just take some fine sandpaper to the magnets in the flywheel. After sanding, wipe it clean, then spray it with carb cleaner to remove any possible residue. Now give the magnets a spray coating of clear polyurethane coating. The flywheel will never rust again. Replace the source coil and install a new spark plug. A plug that is carboned up can lessen spark voltage. The last item is the battery. A weak one can rob power. Please rate my answer. Thanks.
1,616 views
Usually answered in minutes!
×