I dont have a owners manual for my truck and i was just wondering how many quarts of oil do i need durin change, what oil is recomended, and what gasoline is recomended

Put four litres or quarts in and check the level with dip stick if its down some then add another part litre or quart till its up where it should be.

BEST TO LET DEALERSHIP CHANGE ENGINE OIL.YOU NEED A DEALERSHIP OIL FILTER.YOUR OIL FILTER INSIDE A HOUSING ON FRONT SIDE OF THE ENGINE. CHANGING YOUR OWN OIL NOT HARD.YOU NEED 9 QUARTS OF OIL LOOK INSIDE GLOVECOMPARTMENT FOR OWNERS MANUAL TO SEE WHAT TYPE OF ENGINE OIL YOU NEED TO USE AND HOW MANY QUARTS.IF YOU DONT CHECK READ MANUAL TO SEE WHAT OIL TYPE AND QUARTS YOU NEED. IF YOU BLOW OR DAMAGE THE ENGINE WARRANTY WILL NOT COVER THE ENGINE.FIRST OF ALL TO CHANGE ENGINE OIL YOU CRANK VECHICLE UP LET IDLE FEW MINUTES TO THIN OUT OIL THEN YOU TURN OFF ENGINE. YOU NEED TO RAISE VECHICLE USING THE FACTORY JACK.USE JACK STANDS. LOOK IN OWNERS FOR CAR JACK LIFTING LOCATIONS TO KEEP FROM DAMAGING ROCKER PANELS. AND PLACE A DRAIN PAN UNDER THE OIL PAN. UNDER THE VECHICLE.YOU NEED A WRENCH TO REMOVE OIL PAN DRAIN PLUG.WHEN ALL THE OLD OIL DRAIN OUT IN THE DRAIN PAN.SCREW BACK IN THE DRAIN PLUG TIGHTEN IT DONT OVER TIGHTEN STRIP THREADS.THEN YOU NEED SOCKET TYPE OIL WRENCH YOU USE WITH A 3/8 RATCHET WRENCH REMOVE OIL FILTER HOUSING.PLACE RAGS AROUND THE OIL FILTER HOUSING TO CATCH OIL SPILL. YOU WILL NEED TO GO TO THE DEALERSHIP FOR THE OIL FILTER AND FILTER HOUSING O RINGS. ONCE YOU GET NEW OIL FILTER AND O - RINGS INSTALL THEM IN THE OIL FILTER HOUSING.LOCATED OIL FILLER CAP ON VALVE COVER UNDER THE HOOD.REMOVE OIL FILLER CAP.POUR OIL IN ENGINE USING A FUNNEL.ENGINE HOLDS ABOUT 8.5 TO 9.0 QUARTS OIL. BUT LOOK IN THE OWNERS MANUAL CHECK HOW MANY QUARTS ENGINE NEED.CHECK OIL DIP STICK OIL LEVEL SHOULD BE ON THE FULL MARK ON THE ENGINE OIL DIP STICK.TO BE ON THE SAFE SIDE BUY 10 QUARTS OF OIL FOR A EXTRA.DONT OVER FILL MAKE SURE YOUR OIL LEVEL CORRECT.OIL DRAIN PLUG AND OIL FILTER TIGHT BEFORE CRANKING THE ENGINE.LOOK IN THE OWNERS MANUAL FOR OIL DIP STICK AND LOCATION.

You do not list the engine size. This truck comes with 3 engines. 5.4 V8, 7.3 Diesel, and a V10. Your owner's manual will list the capacity. The add mark normally means add 1 quart on a V8. Add 1/2 quart wait 5 minutes and check the level again. The 5.4 L V8 capacity is 6 quarts of 5w20 with filter change. If it is a diesel then it requires a special oil for diesels which is 15w40 weight and it holds 14.5 quarts.

4 quarts including filter change. After filling, let settle and check dipstick.

5W30 it is printed on the oil fill cap

Look in the owners manual in the glove box under fluids, that will tell you. If you don't have one-------- about 4 to 4 1/2 qts. with filter 5w/30 high milage oil, can use pennzoil, mobile, quaker state, any known brand.

Should be using 10w30 or 10w40. You probably have a lifter knocking. Instead of using 5 quarts of oil replace one of the quarts with an oil additive. I use a quart of Lucas Oil in my vehicles every oil change. The stuff works wonders!

I don't have a owners maual either but I beleive its 10 liters.Use 15w40 ams oil with ams oil filter.7500-10000 miles for filter changes and 20000 miles between oil changes

Check the engine oil level. if low add 1/2 quart and re check untill full. GO get oil change. DO NOT RUN if oil is not showing on the dip stick. The oil weight is in the owners manual.

it should tell you on the cap of the oil what oil and start with 4 qrt and then let sit for a few minutes then chec dipstick usauly its 5 qrts