SOURCE: error code yamaha r6 2007 51 how can i erase it?
could be a safety shutdown by computer, only your dealer can erase the code....and then you'll find out whats wrong...and why the computer doesn't want you starting and damaging the bike.......Good Luck to you friend....Tim
SOURCE: my speedometer on my 2000 yamaha r6 doesnt work
broken cable if your style bike has that style system, the cable that attaches to the axle shired off, i"ve had that stripped out also before and had to replace it.
SOURCE: i need the color of my 2007 yamaha r6
The dealer or an automotive paint/autobody shop can tell you where the vehicle ID plate. This is different from the VIN plate. Locations differ by make and year. Fastened to a frame member usually.
SOURCE: my 2008 yamaha r6 will not start fault code 60 is
This is from the service manual.
Fault code No.: 60
Symptom: Throttle servo motor: open or short circuit detected. Defective throttle servo motor. Malfunction in ECU (servo motor driving system).
Probable cause of malfunction:
•Open or short circuit in wire harness.
•Defective throttle servo motor (potentiometer circuit).
•Stuck throttle servo motor (mechanism).
•Stuck throttle servo motor (motor).
•Malfunction in ECU.
SOURCE: 1999 YZF-R6: Yamaha YZF-R6 1999 Clutch feels very stiff. Does t...
THE OPERATION OF THE CLUTH ON HIS MODEL IS OF CABLE TYPE, IF THE CLUTCH IS OPPERATING CORRECTLY THE 1ST THING TO CHECK WOULD BE THE CABLE, REMOVE THE CABLE YOU SHOULD BE ABLE TO PULL THE INNER WIRE SMOOTHLY TO AND FRO, IF YOU NEED TO USE ALOT OF EFORT TO DO THIS THEN YOU WILL NEED TO REPLACE THE CABLE,MAKING SURE YOU HAVE ADEQUIT FREE PLAY AT THE LEVER WHEN RE FITTED. OBSERVE THE ROUTE THE CABLE TAKES BEFORE REMOVAL AND REPLACE IN THE SAME WAY, YOU MAY ALSO TRY TO GET SOME LITE OIL DOWN THE CABLE, THOUGH I SUSPECT THIS WILL BE ALMOST INPOSSIBLE IF IT IS THIS TIGHT TO OPPERATE
535 views
Usually answered in minutes!
×