Just inside the frame from the battery, there's a "jackbolt" that raises and lowers the battery tray. Turning the bolt counterclockwise lowers the battery tray and vice versa. You must loosen two bolts on the right side of the frame just behind the battery box between the battery box and the rear fender. Once the battery is lowered, you'll be able to get the top cover off and disconnect the battery cables. Disconnect the negative first when taking the battery out. Connect the negative last when installing the battery.
Good Luck
steve
SOURCE: How to remove battery cover of 08 Dyna Super Glide
There are two bolts to the left of the battery cover one holds the bracket the other lowers the battery
IGNITION SWITCH for 2007 FXDWG, FXDC Models
First remove seat and then disconnect the negative battery cable and put some tape over the end or otherwise ensure it is insulated such that it could not touch any bare frame part or the battery negative terminal. Next remove the two fasteners that secure the instrument panel to the fuel tank and remove the panel noting the position and colour of the switch wire connectors and disconnect the wires. Then remove the four switch mounting screws and replace the switch. Then reconnect the switch wire connectors in their original positions and re-install the instrument panel with the two instrument panel installation screws and tighten the acorn nut to 18-24 in-lbs or (2.03-2.71 Nm). Then reconnect the battery cable and install the seat and check to ensure that the seat is firmly and properly in place.
567 views
Usually answered in minutes!
×