SOURCE: Removing the battery for a 2004 Dyna Low Rider
Yes, both bolts are to the left of the battery as you face the bike. One removes out towards you (first), the other loosens downward (second). As you loosen the bolt the battery tray will move down. You do not need to remove the second bolt. Only loosen it until the chrome battery cover clears the frame. Once clear, remove the top and side covers. Good luck
SOURCE: 93 Dyna low rider fork oil.
your local hd shop should be able to answer this for you as its a mesured amount and to much or too little will make the bike not handle right
SOURCE: how do you remove battery from dyna low rider
I have an early model and I think they're still the same in that area. There are two bolts on the right side of the battery support. Loosen these two bolts and the battery will drop down a bit allowing you to remove the battery top cover and front cover.
SOURCE: how to remove starter clutch on a 1998 Dyna Low
The starter clutch is an integral part of the starter assembly itself. You must remove the starter and disassemble it to get the "overrunning clutch" out. First take the starter off the bike. Then, remove the two long bolts and take the starter motor off of the drive housing. Then remove the bolts that hold the drive housing together. The overrunning clutch will come out of the drive housing. You will probably have to take the bearings off the original clutch and reinstall them on the new part. Reassemble the starter and reinstall it on the bike.
SOURCE: how do I change the battery on my 03 Dyna low rider
just left of the battery is two bolts remove the bottom one and loosen the other to lower the battery remove cover and side cover pull battery out a little and remove the neg. cable first then you should be able to to the battery out a little more to get to the pos.
443 views
Usually answered in minutes!
×