Do I need an extra wiring kit to Instally boom audio on my 07 street bob? I'm half way don with the install and I can't get any further they said something about a yellow wire but I don't have any yellow wire pl help thx!

SOURCE: need help !!

have you tried there web site for the wireing instructions or manual to installing it.
Programmable thermostats at discount prices at
hunter-thermostats.com.


riz.

SOURCE: What wiring harness and deck install kit?

My husband and I just installed a Pioneer DEH-2000 MP today in my 2004 Sentra, which we bought at Electronic Express. They didn't have the wiring harness or the install kit we needed, but Best Buy did. Just go there or some other electronics/car audio place and tell them what vehicle you are installing your stereo into. Make sure you do have all the same color wires and numbers of them on your harness(s) as you do for your stereo - they should of course match, and the plugs of the harnesses will match those of your truck. Don't freak out if you don't use all the plugs in your truck though - one may be left because it was proprietary to your stock radio. A couple of good install kit brands are Scosche and Metra - both use factory colors and molding that will match the color and lines of your dash to make it look as integrated as possible.
Hope that helps!

ZJ Limited

• 17989 Answers
• Posted on Feb 18, 2009

SOURCE: wiring diagram 07 jeep laredo

Check this info...
- WJ-2002-Cherokee-Service-Manual-PDF-08F-Sistema-de-Audio - Audio Systems / Page 17 8F 17 and next (spanish).
- WJ-2002-Cherokee-Service-Manual-PDF-08W-Diagrama-de-Cableado - Wiring Diagrams / Page 259 8W 47-1 and next (spanish).

Good luck!!!

SOURCE: 07 Street Bob. At 9000 miles, the engine mounts

You have a torn engine mount, if your bike is still under warranty get it to your dealer asap!!!!! The same thing happened to my 08 Superglide, the dealer was quick to fix it as I had no idea as to why my bike was shaking so badly. Also check that your tank mounts are tight too..
Good luck!

Gar

• 384 Answers
• Posted on Oct 10, 2009

SOURCE: 07 harley street bob. front fork seal leaking

Not very common, but I don't see how the seal could scratch the tube. There are a few millimeters of clearance between the tube and metal part of the seal. The rubber seal rubs the tube and is bonded to the metal ring. Either the tube was scratched during assembly or the seal was BADLY dented somehow. Further, the tube is hard chromed and the seal metal is soft steel. Go figure!