2008 Harley Davidson FLHX Street Glide Logo

Related Topics:

Posted on Oct 16, 2010

Abs light stays it shows code C1032 - 2008 Harley Davidson FLHX Street Glide

1 Related Answer

Anonymous

  • 1509 Answers
  • Posted on May 21, 2010

SOURCE: my abs brake light comes on when I turn right

I'd look for wiring frm the handlebars going to the frame for binding and chafing. Being it does it going only to the right gives a clue that it's not an ABS problem as much as a streched wire problem.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Harley 2012 road glide custom cvo trouble code C1021 and C1032.

Its possible that the ABS sensor is not reading the "trigger" mechanism on the wheel properly. If you changed from a 19 to a 23 inch wheel, the sensor will think that the wheel is turning too fast or too slow and cause the ABS sensor to flash. There is probably a different sensor plate or sensor for the larger wheel.
1helpful
2answers

I have a c1032 abs code, what is it and how do i fix it. 2006 Jeep Liberty 4x4

Right Rear Wheel Speed Sensor Signal Erratic Performance . Videos on youtube showing how to test the sensor , plus check tone ring .
0helpful
1answer

ABS or Traction control light stays on in a 2002 fairlaine ghia

Both units use the same rotors and sensors . Run the fault codes to determine which unit shows up as faulty.
0helpful
1answer

Freelander abs

Sounds like the RF speed sensor is bad, normally you can set a multimeter to ohms and put it on the disconnected wheel sensor and see if you get a reading off the sensor. If you do, then the sensor is ok, and may be the ring on the drive shaft.
I would swap the sensor out and reset the codes.
1helpful
2answers

Abs light showing on dash board

Whenever abs light is on there could be a minor or severe damage to the wheel sensor..
Please check the wheel sensor to rectify the problem..
Thank you for using fixya..
Please rate me on fixya to continue my further assistance..
5helpful
2answers

Why does my abs light stay on?

Dear Madam or Sir,

this is possibly due to a faulty ABS-Wheel-Speed-Sensor. There is one mounted to each wheel, the ABS control unit compares all four signals to compute the moment to intervent. If there is one signal unplausible or missing, the control light will appear to show you that there was an error recognized and stored to the control unit´s memory.

You should see the shop to access the fault memory via diagnosis eqiupment to get to the heart of the matter.

Kind regards from Germany,

AutoDoc P. :)
0helpful
1answer

My abs brake light comes on when I turn right

I'd look for wiring frm the handlebars going to the frame for binding and chafing. Being it does it going only to the right gives a clue that it's not an ABS problem as much as a streched wire problem.
0helpful
1answer

My ABS light constantly stays on what can I do to

This indicates a problem some where in the ABS system. Get the cars computer scanned for error codes , This should nail the problem .replace or repair the component that shows the error .All done and happy motoring.
Not finding what you are looking for?

1,092 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...