I own a Honda VT1100C, I needed to replace the starter motor in doing so I had to release the clutch slave cylinder.I tried to bleed the clutch after I had fixed the starter with no joy. I have replaced the seals in the master cylinder and the slave cylinder but still no joy.Is there a special way to bleed the clutch. this is a 1993 shadow.
SOURCE: how do I bleed the clutch on a 93 honda shadow VT1100C
Hydrolic failure is caused by mixing hydroscopic (DOT3) with petrolium based (DOT5) ater and oils don't mix. Blockage at return port won't allow fluid to return to master cylinder. Clutch will not engage if this were the case. The leak would be your best tell. Not knowing exact leak location it would be hard to say. inspection of master cylinder plunger seals couldn't hurt. If dissimular fluids have been mixed all rubber components have been contaminated and must be replaced
SOURCE: i am trying to fix
i would look to a faulty seal in the slave cylinder, but would expect to find a fluid leak also above that i cant help
SOURCE: Can a 94 Honda Shadow VT 1100 front mag wheel fit on a 87 Honda Shadow VT 1100
check cheapcycleparts com micro fiches for your standard wheel, parts list will tell you what bike it will fit when you click on the wheel .
390 views
Usually answered in minutes!
×