How to open seat - 2007 Bajaj Platina

If you misplaced your key and want to open the seat storage of your Suzuki Access then, you just have to twist the ignition hole that is provided in your scooter and it will unlock your under-seat storage. For more clarification, I have provided a video to to open Suzuki Access125 seat lock, have a look

what year? pull cable under seat on some? (under plastic ) has looped cable , just pull it. along edge of seat on others small lever pull up towards seat.

Open tool box, at rear of seat, with key and unhook or unbolt the seat from inside tool box.

Pull lever on right or left side, up under the seat. It can also be at the rear of the seat, right or left side, again up under the seat. Lift seat off up and to the rear. Sometimes it's hooked on both sides with a rod or cable connecting both sides. These can break. Make sure both are unhooking.

Same as above only you use a key.

Remove the two bolts on either side at the rear of the seat. Pull seat to rear.

Nuts or bolts, at the rear and below seat, under the rear fender Remove bolts holding down the rear seat . Remove seat and then remove two bolts, at the rear, holding the front seat on.

Unlock lever on side of seat. Seat then pivots on two hinges to open. Can open to the right or left. Might have no lock.

Push button on side. Left side, I haven't found a push button on the right side... yet ! Can be locked or unlocked with a key.

Pull lever at front of seat, right or left side. Seat lifts up with the hinge at the rear.

Pull lever at rear of seat, right or left side. Seat lifts up with hinge at front.

Pull lever at front of seat, right or left, and whole seat comes off. Seat has pegs underneath that fit into rubber grommets on the frame.

turn ignition key to the left this opens the seat !

some have a split seat that opens up. and some do not. look in the trunk and see if it has a release for the back seat.

If it's the new model then you need to follow this in reverse order for Cleaning the Quinny Buzz seats (comfort cushion and XL seat)
1. Open safety harness
2. Unfasten the shoulder belt snap and hook and remove the belt pad.
3. Loosen all snaps on the bottom of the seat
4. Loosen the Velcro straps on the bottom of the seat. Remove the belt buckle through the opening of the seat
5. Slide the cord of the seats out of the edges of the Quinny Buzz seat. Start with the foot section and work towards the head section
6. Pull the lap belt of the Quinny Buzz seat through the holes of the seats and remove the loops from the shoulder belts from the openings of the seat

Seat--- To open the seat:--- 1. Place the scooter on the centerstand.-- 2. Insert the key into the main--- switch, and then turn it counterclockwise to “OPEN”.--- NOTE:
Do not push inward when turning the
key.
3. Fold the seat up.


-----------------------------------------------------------------
To close the seat
1. Fold the seat down, and then
push it down to lock it in place.
2. Remove the key from the main
switch if the scooter will be left
unattended.
NOTE:
Make sure that the seat is properly
secured before riding.-----------------

This will help. Thanks please keep updated.please please do rate the solution positively .thank you for using fixya

the rear seat dosent flip down in this model just the small opening behind the arm rest opens . to allow you to ccarry snow skis and such.

open the side panel then open the bolt of seat and slide seat the seat is open