Where is the fusebox on Kawasaki zx12r - ZX-12R kawasaki Motorcycles

The front and rear tire pressure on a ZX12R is 41psi.

The engine will fit in the frame but the head support will not bolt up. The timing is also very different on these two years. The heads would have to be switched, including the cams, so unless you are a seasoned mechanic I think you should avoid this one.

To change oil remove drain plug under bike, while oil is draining into pan remove left lower fairing and remove oil filter from front of engine. Replace plug and filter and refill, replace fairing.

http://www.motoverse.com/tools/vin/kawasaki.asp

Go to the above lnk and type in your entire VIN. You have only displayed 13 digits only of 17.

Get the power for you heated grips directly from the ignition switch. Use a test light to determine which wire to use. You're looking for a "switched" wire, one that goes on and off with the switch.

try wire brushing the connections

check your ignition switch to make sure its in the on position, also make sure you have a good battery and the cables are clean and connected properly

the clutch disks are stuck together