1996 dodge neon has gas but no spark i change the ignition coil but still wont start what could it be is it the crank sensor or fuse

Primary voltage to several systems, including the ignition coil, dark green wire with orange tracer. That voltage comes from asd relay. There is a fuse for asd relay. To check for voltage the engine has to cranking. The control side of asd relay, the computer has to ground it before it will energize. Did you check wiring circuits for cam and crank sensor connectors before replacing sensors? Are there any applicable trouble codes?
Are you ok with testing wiring circuits?

have you checked the coil(s) or ignition module?

What year? First check for spark at any of the sparkplugs.If you have spark and fuel pressure then take the mass air flow sensor off and clean the small thin wires inside with a non-chlronated brake cleaner and let it dry for 10-15 minutes then re-install it and see if it will start.

the crank sensor is on the back side of the engine just above the oil pan there will be two sensors there one is the crank sensor and the other is oil presser sensor. All so check the wires from the crank sensor to the cam sensor. If you think it is the timing belt pull the cover and check it. hope this helps.

If the Starter isn't turning the engine over, but you hear a clicking sound, you may have a bad Starter.
If the Starter is turning the engine over, but you are getting no Spark, you may have a failed Camshaft or Crankshaft Position Sensor, or your Timing Belt may have jumped or broken(common on the neons).
If the Starter is turning the engine over, but you are getting Spark, you may have a failed fuel pump, fuel pump relay, or fuel pressure regulator.

Before you start replacing sensor, double check the Timing belt to ensure it hasn't broken or jumped, and check to see if you are getting a spark or not.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

ignition switch

Change the cam sensor. I had the same problem you did and once i change this little sensor, car started right up!

p0352 is ignition coil #2 primary circuit..the engine controller had these circuit problems in this model year..also have seen a crank sensor cause this fault also..if it's not the crank sensor,most likely engine controller

Might as well try the idle air control valve, or the mass air flow sensor. Sounds like you've almost hit them all!

those car are bad for crank sensor there in the back of motor in the engine block check it out hope it help fixya our post thanks pierre