What oil filters work with 2002 kawasaki zx6r?

Do you know where the oil filler neck is (left side above your clutch foot lever - a twist cap), the crankcase bolt (size 19) normally just in from of your centre stand, your oil filter normally in the engine centre (it is like a hump/bump-bolt 12). Hope this help. Good?

Try a bike shop for Kawasaki or even a car part shop that has listing for motorbike filters and normally they also sell the oil. Check your owners maual for the SAE requirement. You can try Castrol or Belray website. Good luck

it sounds like there is to much oil in the engine the same thing happened to my zx6r, hold the bike upright on level ground then check oil level on the glass viewing window which is on the right hand side of engine, you should see oil level between the low and high marks, if level is above top line you will need to drain some oil out by undoing sump bolt or using a siphon, when ever checking oil level bike needs to be upright on levelish ground some people check oil levels when bike is on side stand which is wrong as it shows oil level as low when in-fact its probably right

Are all the plugs properly tightened & are all the leads on properly give them all agood firm push occasionally they can feel like they are on & besitting lose on top is the air filter element sitting correctly It may be causing an obstuction of the air intake if you have used an after market air filter it could be that it is heavier than the standard item & restricting air flow

Try this manual, it should cover all your needs. Are you sure you have the correct rating fuse in the box, the manual will solve the problem any way. Good luck:

http://vitek.vellum.cz/manualy/Kawasaki%20Ninja%20ZX-6R%2000-02%20Service%20manual.pdf

Did you cahnge the filter also? Have you ran the motor to build pressure and fill the oil filter. The light should go out when the oil gets pumped threw the filter and engine.

2 qts even with filter. 10-40 bike oil only, must be type t or be certified for wet clutch use. will say on the back of bottle, most auto parts have it

Depends if the oil and filter and oil cooler have been dismantled. If not and only the old oil has been drained it should be approx 4lr's, should state this under the oil filler as a guide. If its a complete strip down and rebuild your'll need at least 4.5ltr - 5ltr's so put in 4.5 and run for 5 mins, then check level

the horn is only held on by 1 bolt,undo this and remove the 2 wires then just reverse these steps to refit