How do i install my kickstart and get the gears to engage, when i crank the bike over it just sounds like the gears are not engaging and the kickstart drops to the floor, how do i solve this problem?
SOURCE: '95 Yamaha YZ 125 clutch - stays in gear when clutch is pulled in
hey dude,, just thought id come in and give u some tips or 3,, i take it when u pull clutch lever in, and try and change gear it feels like your foot will snap b4 it goes in gear,, if that makes sense,, firstly mate,is to make sure the clutch cable slides freely ,easest way is to take cable off and just grab 1 end and make sure it isnt sticky,, if so dip one end of the cable in a bit of old oil ,,whilst holdin the other end ,pull and push the cable inner, this will **** up a bit of lubricant inside the cable ,, keep doin this each end till free to move, ,,next step if the cables ok,,, and may need help if u dont no,drain the oil out,,and as u r sat on the bike is to remove the clutch casing on the right hand side of the moter,where the bottom end of the cable goes,remove the casing being carefull not damage the gasket,,then u will see clutch plates and friction plates housed,, undo the 7 or 8 spring loaded bolts carefully take the first fibre plate out then metal friction plate then another fibre plate and so on,, wen u take the 1st plate out place that on the bench ,stacking each plate on top of one another, cause they have to go back in as they came out,,wen out,,u need a piece of wet n dry paper ,or fine emery,,and just wipe round both sides of the fibre plates taking the shine off them,as u put them back in,, put casing back on with a decent gasket,, oil back in cable on, make sure cable has no free play on the lever so wen u r about to pull lever in it bite straight away,, start her up, warm it up and try it,,any probs still il eat my shoe,, take care m8
SOURCE: Loud sound while engaging into gear..etc...
If the idle is too high it can clunk but it usualy make this noise..Does the clutch drag? If not leave it alone.
timming? as a general rule NO. Backfire leaking exahust sucking fresh air in to it or idle mixtures upset...
SOURCE: engaging 1st gear the gear grinds an clunks into
This happens when the parts of gear box is not proper due to misalignment. hence service the gear box first.... also change the oil and all the ball bearings of the gear box ... lubricate every parts in gear box.
SOURCE: Yamaha 2001 Raptor 660, need to clean my carb
Drain and replace the gas with fresh.
Remove the air cleaner and spray carb cleaner into the inlet. Work your throttle a little then put everything back together and try to start it.
SOURCE: I own a 1986 Yamaha VMAX 1200. When the bike is
I assume the noise is a high piched grinding noise as thats the most common problem that I have seen on mid '80s yamaha bikes. If that doesn't describe your noise let me know, but if it does you may have a worn starter or.
521 views
Usually answered in minutes!
×