Got an old spyball alarm (green rectangular key fob with a black stripe and two buttons). I believe its the 6527. Battery ran down and forgot itself... Using the recessed button and holding it down for about 30 seconds it remembered itself. However while it is now allowing me to to start the bike I believe I have turned off the alarm system and I suspect the immobiliser and assume there is a process involving button pressing in a set order to reset the alarm. Anyone know the routine? The second key fob does not appear to work at all, can they be repaired? Any help much appreciated! Ben
Re: Got an old spyball alarm (green rectangular key fob...
You have to pussh the left button for one second and then again for 15 seconds (according to the manual, for me this is not working), maybe for you it will do the trick
you must press left (1) buton on the switched off ignition and hold , then switch on the ignition and keep holding until alarm turned onyou must press left (1) buton on the switched off ignition and hold , then switch on the ignition and keep holding until alarm turned on
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
More than likely you will have to re-sync your keyfob to the car. Your owners manual may have the steps needed to do this. What year/make/model of vehicle is it?
You need to reset the alarm system.That can be done with the remote entry key fob or by locking then unlocking the drivers door with the ignition key with all doors closed.This is for a factory alarm system.Also check the inertia switch,should be in the trunk,on the side with a push button top.Push button.If already down its not tripped.
Sounds like alarm has been set off,all the bells an whistles have stopped now it's in anti theft mode.Try disconnecting neg.wire on battery for a couple minutes and then reconnect.Alarm should go off.Take fob an shut alarm off like normal and that should do it.
×