How to open seat on peugeot looxor scooter, just

If you buy the pinion you also have to buy the rest. Also on the axle is a circlip wich you must use. Otherwise the Carter where the axe is going in will be worn out. That is a problem if the starter is not working. They use the kickstarter to much. Its only a help not a thing to use each day. The parts for this are here.
Its number 4 on the drawing you need.
https://goparts.eu/en/blueprint/peugeot/scooter/2011/fight-3/clutch

And here is the number 3 thats most of the times is also worm out.
For using it properly you need Numbers
1-3-4-5 and number 6 is the ond you Jane bought already.
https://goparts.eu/en/blueprint/peugeot/scooter/2011/fight-3/drive-shafts-kickstarter

Peugeot vivacity variator - YouTube

? 5:41
https://www.youtube.com/watch?v=VmvXD0QMHog
Aug 24, 2012 - Uploaded by James Parus
this works probably only with 50cc versions, as 125's are probably not limited at all. ..... Do you know what is the size of the rollers in vivacity 3? I just bought one and want to derestrict it and changethe rollers since they seam to be ... 2008 PEUGEOT VIVACITY 350 SCOOTER MOPED VGC 8.3K MILES 2 ...

How To Replace / Rebuild Your Brake Master Cylinder ...

? 17:43
https://www.youtube.com/watch?v=JqX2GUutPvU
Jul 2, 2014 - Uploaded by Scudo Camper
How To Replace / Rebuild Your Brake Master Cylinder .... Quickquestion - do you not use nitrile gloves to protect you from skin contamination?Missing: 2008 ‎tkr ‎50

2008 Peugeot TKR 50 specifications and pictures - Bikez.com

www.bikez.com/motorcycles/peugeot_tkr_50_2008.php

The 2008 Peugeot TKR 50 and all other motorcycles made since 1970. Specifications. Pictures. Rating. Discussions.
Search Results

How to change cylinder on a scooter - YouTube

? 6:29
https://www.youtube.com/watch?v=bUrlKLeGgjo
May 26, 2011 - Uploaded by HasSse666
How to change cylinder on a scooter (vivacity speedfight) ...50cc to Big Bore 80cc Scooter Rebuild/upgrade Kit How to do it Racing Upgrades ...

50cc Cylinder Barrel Gaskets Peugeot Trekker Speedfight 1 ...

www.ebay.co.uk > ... > Scooter Parts > Other Scooter Parts

eBay50cc Cylinder Barrel Gaskets Peugeot Trekker Speedfight 1 I 2 II Elyseo Buxy AC in Vehicle Parts ... Intended Use: Replacement Part ... Peugeot Elyseo 50i AIR 2T 2002-2007; Peugeot Elystar 50 AIR 2T from 2008; Peugeot Elystar 50i AIR 2T from 2008 ...All pictures are taken by us so you will receive exactly what you see.

Peugeot TKR 50 2011 Replica Cylinder Head Gasket ' eBay

Make sure that a ground wire is not near the area you worked on or any wiring for that matter that may have been bumped during shock replacement .

I just brought a Peugeot XPS ct125. And do not know how to take the seat off??

I Have the same problem, but I think is only a bad wire connection in a box under sit driver. I'll check next weekend.

I had this problem too in a Renault clio 2 v2, and renault just cut the wires plugs and put it together directly using a soldering iron.

try giving your carb a clean with a scooter there isnt timing there all belt driven is it a 50cc or higher

low compression. weak ignition. burnt valve seat. improper timing. etc.

Most adults have excellent records of never breaking a belt. Here is the reason why many kids break their belts,--- If you hop a curve, you must let go of the throttle. DO NOT have the throttle on wide open (full open) and hop a curve. If you do when the rear wheel comes off the ground, the rear wheel spins faster. When the scooter lands and the rear wheel hits the ground, you stop the tire from spinning, it will snap the belt. If you do hop a curve, let go of the throttle. When you land give it a little throttle. As you pick up speed then give it full throttle.

take it you have done it------- two brackets at front of seat