SOURCE: where is the oil filter on my yamaha V-star 1100
On the right side of the bike (right side when ou are sitting on it) just above the rear brake lever behind a small circular plate. remove the plate and the oil filter is inside (you will easily see it). Warning---on these bikes you have to drop the front exhaust header and right floor board in order to change the oil filter unless you install a after market oil filter relocation kit. If you plan on changing your own oil it is highly recommended to install this relocation kit.
SOURCE: setting float level on HSC40 Hitachi carburetors on 1986 Virago
I have a 1982 Virago 750 that I just did a carb rebuild to. To set the float levels I built a jig from wood that simulates the position of the carbs when mounted on the bike. This jig clamps into my bench vise. I created a fuel supply using a small funnel and a piece of fuel hose mounted above the level of the carbs.. After that all you need is a short length of transparent fuel hose to attach to the drain on the bottom of the float bowl to provide the visual indication of the float setting. Now you are ready to set up the float levels on your bench. This is way easier than trying to set them up in the bike.
Make sure that the jig is set up so that the carbs sit as level as possible across the pair and that they sit as close to the natural position in the bike in the lengthwise position when the bike is sitting level.
The process of setting up these floats can be very tedious, be patient. It may require that the float bowls be removed multiple times to get it correct (I replaced the philips head machine screws with allen head screws to make this easier). Printed instructions for the procedure look for a certain fuel level setting plus or minus 1mm. This kind of tolerance can be quite difficult to get when the only adjustment you have to work with is to bend the metal tang on the float assembly.
SOURCE: needle n seat adjustment yamaha virago 920
Hello dnjvp...The Hitachi HSC 40mm carbs on the 920 can be jetted and modded as needed to give you the right mixture for any engine or exhaust modifications.
Here is the breakdown for the slide and the internal parts. Check the needle for wear, clean all parts and put back together. Make sure you hold the diaphragm up to the light and check for pinholes. If any are found use a sealer like to fix.
Good luck...i hope this helps.
SOURCE: need setting for carb. adjuster on bottom of carb
Turn the adjusting screw all the way in until it LIGHTLY seats. Now back it out one and one half turns. Do the same adjustment for the throttle screw on the right side of the carb. You are now back to the stock factory settings.
Could you take a moment and rate my answer? Thanks!
SOURCE: Yamaha 1100 Drag Star 2001 Custom motor starter,
These parts are fairly reliable. Rather than buying new, you should be able to pick one up from a motorcycle breaker who will post it to you. I would expect to pay about £60-£100 tops in the UK (Depending on mileage). ANy Yamaha dealer will be happy to order you one new, but they are a hell of a price!
309 views
Usually answered in minutes!
×