Question about 2008 Keeway Outlook 150
The engine temperature is usually very hot @
Posted by Anonymous on
Hi, Anonymous and the usual suspects are:
1. Low coolant level.
2. Restricted radiator airflow.
3. Faulty thermostat.
4. Coolant pump or fans inoperative.
5. Vent hose crimped.
6. The air in the coolant and needs bleeding.
7. Engine idling too long or bike moving too slow.
8. Coolant too old needs to be replaced.
9. Faulty temperature sensor, wiring or connector.
10. Radiator veins clogged or corroded needs repair
11. Cooling system leak.
12. Ignition timing retarded.
13. Spark plug heat range too high.
14. Faulty radiator cap.
15. Carburetor jetted too lean.
16. Damaged top end.
17. Blown head gasket.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Posted on Oct 05, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
check for a small brass screw on the carb. if it is on the filter side it is a air adjust screw, turn it out to lean out the carb. if it is on the intake side, it is a fuel adjust screw, screw it out to make it richer. the easiest way to adjust is to turn it slowly one way or another until you get the highest idle without touching the throttle, then adjust back down with the idle adjust screw.
Posted on Jun 13, 2010
You have to remove all the front panel along with the headlights that come together, I haven't found another way to do it.
Iwish I had a beter solution but that's all I can suggest
Thanks and good luck
Posted on Dec 17, 2010
The only thing I can think of is a bad connection behind the key switch it could cause a fire so you need the fix it ,just un screw the switch and clean all connection points mind grease them to stop them oxidising best of luck
Posted on Jun 06, 2014
Tips for a great answer:
Oct 20, 2017 | John Deere Garden
May 16, 2015 | 1966 Ford Mustang
Dec 30, 2014 | Cars & Trucks
Apr 12, 2013 | 2002 Hyundai Elantra GT
Dec 10, 2012 | 2000 Toyota Sienna
Jun 18, 2011 | 1998 Ford Taurus
Nov 03, 2010 | 1995 Chevrolet Caprice Classic
Jul 13, 2010 | 1996 Pontiac Sunfire
Sep 07, 2009 | 1997 Plymouth Voyager
43 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: