Hi, I turn ignition on and neutral and engine light come on but thr usual fuel pump priming to not happen, the enginr light still goes of after a few seconds. bike does not start as no fuel being pumped. put new pump in and worked for a short while and same symptoms came back, any ideas please thanks simon
SOURCE: the bike was stolen, replaced the ignition lock, now won't start
well it depends on what kinda of bike your talking about.like on my cbr600rr it has a tip over switch which wont send spark to the engine and you have to replace it.some bikes you can just reset the ecu.i would get a service manual and find out how to reset the ecu and also see if it has a tip over switch.
SOURCE: 2005 yamaha r6 want start. New plugs,replaced all
my yamaha r6 will not start all im getting is clicking
SOURCE: 2005 road star silverado -
Most likely there is something wrong with the kickstand switch - have it checked. Then remove the pump and test it separately on the bench.
If both are good then you had a short in the wiring from the water - have the entire harness tested.
Good Morning,. I found this for you.. worth a shot:
986 views
Usually answered in minutes!
×