How do you check a yamaha dragstar 650 rectifier and alternator with my multimeter
SOURCE: i have a yamaha dragstar
If it has been sitting for a while I strongly recommend you remove the carburetors and clean them thoroughly, you will need to make sure you remove all the jets, especially the pilot jets because that is the smallest jet in the carb that will plug and it is often the one that will prevent the engine from starting.
Try using some WD40 in the back of the carbs when you try to start it after you clean the carbs. I don't like to recommend starting fluid because it is volatile and can easily catch on fire if the engine backfires.
I'd also recommend replacing the spark plugs as well. Make sure you have good fire. (turn the motor over with the plugs out and grounded on the head to make sure you can see the spark)
I also recommend pouring a small amount of Marvel Mystry oil down each spark plug hole to help "reseal" the rings. Remember that sitting is not your friend and you may have to get the rings back to life by using the special oil.
Just remember you need three basic elements to make an engine run:
If you have all three of those and compression your engine will start.
Let me know if you have any further questions.
Regards,
RSelvy
SOURCE: problem with shaft drive (cardan) for my Yamaha Dragstar
SKU: 5FB-Y4617-00-00
SHAFT DRIVE SUB ASSY
SKU: 5FB-Y4617-00-00
SHAFT DRIVE SUB ASSY
Hi i just checked on stadium yamaha site and above is the SKU # for both, 98 and 03.... both the same so go for it
http://www.stadiumyamaha.com/pages/parts/viewbybrand/parts.aspx
SOURCE: what is the tire pressure for a yamaha 650
your tire manufacurer print on the sidewall the required pressure for your application. you should follow this restriction as required for your tire rating and application
SOURCE: 02 Yamaha xvs 650 dragstar classic that misfires when it warms up
First I would change all the spark plugs, and if that didn't make a difference then it sounds like the coil(s) are warming up and breaking down........when it starts to skip take a good pair of pliers with good rubber on them and pull each spark plug wire, when you get to the one that the running doesn't change then I would replace that particular coil
SOURCE: 1999 yamaha dragstar paint
Go to a local FinishMaster store and they will use a color eye to find u a color
388 views
Usually answered in minutes!
×