What do i need to do to change headlight bulb on zzr1100

Here's a link on replacing your light bulb on your VW. Sparky Answers 2001 VW Beetle Changing The Low Beam Headlight Bulb HERE'S A VIDEO,ALSO How To Change Head Light Bulb VW Beetle

Change headlight bulb - 2011 Ducati Monster 696 Upgrading Ducati Monster Headlight with Silverstar Ultra H4 Bulb Free Ducati Motorcycle Service Manuals for download Ducati OEM Parts Fiche Lookup and Online Ordering Ducati Maintenance

Follow these steps to change the headlight bulb on your vehicle:

1. Open the engine compartment hood.
2. Locate the back of the headlight to determine the lamp and bulb type.
3. Decide which bulb you need to replace.
4. Purchase the correct bulb for your headlamp.
More items...

Changing a Headlight ' DMV.org

www.dmv.org > how-to-guides > headlight

YOU NEED TO RAISE THE HOOD,YOU HAVE TO REMOVE HEADLIGHT HOUSING BY TWISTING THE HEADLIGHT HOUSING MOUNTING RODS OUT OF THEIR CLIPS AND PULL UP THEM STRAIGHT UP TO DISENGAGE THE HOUSING FROM VECHICLE. WITH HEADLIGHT HOUSING OUT VECHICLE REMOVE LIGHT BULBS, YOU NEED TO WEAR CLEAR PAIR OF LATEX GLOVES WHEN HANDLING NEW HEADLIGHT BULBS BECAUSE HEADLIGHT BULBS ARE HALOGEN BULBS OILS FROM FINGERS OR HANDS CAN CAUSE HALOGEN BULBS OVERHEAT AND BLOW OUT.HALOGEN BULBS VERY EXPENSIVE THEY COST FROM $10.00 UP TO $20.00 OR MORE SO WHERE CLEAN GLOVES WHEN HANDLING BULBS.

You don't have to remove the headlight to change the bulb. The bulb can be removed from the back of the headlight, usually by turning the bezel ring that holds the bulb onto the headlight housing. Just make sure you do not touch the glass part of the bulb while replacing it or it will burn out again fast.

1. Remove headlight unit
2. Disconnect headlight leads
3. Remove bulb cover
4. Remove headlight bulb holder
5. Remove headlight bulb
6. Install new headlight bulb - DO NOT TOUCH THE GLASS PART OF THE BULB!
7. Install headlight bulb holder
8. Install bulb cover
9. Connect headlight leads
10. Install headlight unit

I'm not aware of any shortcuts, nor do I believe that any steps could be changed or eliminated without re-engineering the headlight unit.

Most head light buckets have a couple screws on both side and they need to be removed before you can pull the headlight ring and bulb.

1. Remove headlight mounting bolts and nut
2. Remove assembly
3. Install headlight assembly (with new bulb)
4. Replace/tighten headlight mounting bolts and nut

1. 
   

Reach beind the headlight and just unscrew the cap that holds it in. However don't touch the new bulb with your bare fingers or you will drastically shorten the life of the bulb.

Changing the bulb should not have affected the housing adjustments.

The bulb is just inserted into the headlight housing. The adjustments on the headlight housing is what adjusts the alignment of the headlights.

Did you maybe not get the bulb not seated correctly in the socket? Or didn't get the socket not seated correctly into the housing?