I had BMW 528 model 97 i change the front right ABS sensor and the light in tablet now is off, but when i drive for more than 2 km and some time more the light of ABS coming on and the transmission gear not working properly

most likely speed sensor. the fronts are the same, and the back 2 are the same. but the fronts are not the same as the back. I believe it's the right front for the above problem.

In normal driving engine fault light abnormal light. Diagnosis diagnosis with BMW ICOM.Check exhaust pipe, air inlet pipe; check the sealing of the coking problem, is most likely to damage caused by oxygen sensor.Advised a change of oxygen sensor.

This means the transmission has gone into safe mode. Usually happens if there is an ABS sensor that has gone, is the ABS light illuminated?

sound like wheel sensor.most time when car is moving and abs light come on its the wheel sensor is loose or wiring problem at the electrical connector or sensor going bad.

Sounds like the ABS system has a fault, goto to a Brake specialist to have the system verified.

Check/replace all sensors .. ECU

hello there, i have and bmw 3 series 325ia progressive 2009, and with bmw its a matter of luck to have your car well, now have you kept in touch with the bmw department where you bought it ? if you do, and they dont help you, you can send an email to the bmw of germany complaining about your problems, you have to put every single detail, since when you bought ( year, number of series etc,) and they will contact the bmw from where you bought, and im sure they will respect you and if you have look, they could even give discounts on cars. hope i helped you, good look!

it is caused by low battery voltage run bike for about a mile then stop turn of turn back on wait till abs lights go out then start

abs sensor in one of the wheels is dead

hello , it sounds like you have a bad speed sensor or all 4 of them , see when the speedo plays dead like that is because (most cases ) the sensors at the wheels are bad due to water and normal driving corrosion , the data for the speedo comes from the abs module that monitors the sensors if the abs does not reed it the speedo will not reed it aswell , it will be good to scan the vehicle to see if you need more than 1 sensor there is one in each tire axel ,good luck