How do I remove the main seat on my 2003 gsxr. Is

I think on some Saturn models the seat belt mount bolt, a Torx T40, is hidden behind a 'clip on' cover at the hinge area of the seat. Be patient and gently lever the cover off. As for the air bag, as long as your careful NOT to touch together or 'short out' any wires the air bag should not go off.

I had a 2003 Pilot and if I remember right, there are buttons hidden below the fabric. Look at the rear seat headrests and how they have buttons to push in. They are similar on the front, but hidden below the fabric. You'll have to feel around for them and depress them while pulling up on the headrest.

Remove your seat and in that compartment you'll find your battery and right next to that(depends on what year your bike is)will be another fuse box with a 30 amp fuse in it..Inspect that fuse box for continuity and replace the fuse..When I had a Katana that's what I did and also found the same fusebox in a similar location on my 98 gsxr 750(SRAD)hope this helps..

on the back where it hooks to the floor. pull up on the levers then rock it forward to unlatch it.

Hi, underneath the lefthand fairing pannel is a likely candidate, remove pannel this is the same pannel the front indicator is in, you might get it from the infil under the left handlebar, on later models the fusebox is located just above the gearchange lever, hope this helps

FYI- I'm taking a shot at this one based on my 2003 Montana so take it for what it's worth.
My van seats have a very small level on the drivers side of each seat. Pushing the lever down allows the seats to fold down while pulling the lever up allows them to recline. There is also a small ******** the back side of each seat which when pulled allows them to be folded down.
Hopefully your 2003 Yukon seats are similar to my 2003 Montana seats and this will work for you

There are two bolts (they take allen keys) one on each side of the seat(toward the back before the rear seat pillion or cowl cover) remove those and it will slide to the back to remove it.

This would be a servo for injectors or carbies.

No not without modifying the base - very difficult

Hope this helps (if so please mark as very helpful)

Ride Safe
Bike-Doc

well lets not start with visegips .
the lever needs to be removed by removing the screw and removing the lever.
go to the dealer to get the new lever and put it on.