2000 ford Mustang clutch

The answer is yes, any 5-speed from a 94-04 Mustang (4.6 or 3.8 doesn't matter, it's the same transmission). You'll also need the pedal assembly, shifter assembly, ecu from a 5-speed, 5-speed drive shaft, clutch and clutch cable, and flywheel.
BUT, If u didn't know all that already... let alone the yes or no answer to ur question, I wouldn't advise doing an over

Hello irlandis2002,

Well, it turns out that there four different possibilities for the 302. Below are the four diagrams. I hope this helps.














Regards,
netvan

Here is the link to show you the diagram for the fuse box,copy and paste address into address bar then press enter.
http://www.google.com/imgres?imgurl=http://www.allfordmustangs.com/forums/attachments/5-0l-tech/38405d1200851008-1993-ford-mustang-lx-5-0-ho-fuse-box-diagram-mustangfusebox.gif&imgrefurl=http://www.allfordmustangs.com/forums/5-0l-tech/101590-1993-ford-mustang-lx-5-0-ho-fuse-box-diagram.html&h=690&w=480&sz=24&tbnid=3dhE4qaMvt-AaM:&tbnh=269&tbnw=187&prev=/images%3Fq%3D2000%2Bford%2Bmustang%2Bfuse%2Bbox%2Bdiagram&zoom=1&q=2000+ford+mustang+fuse+box+diagram&hl=en&usg=__9b3JW03hcMINM3UU2F5fYMfXo4k=&sa=X&ei=dn6TTeuSBoLG0QGS-v3MBw&ved=0CBcQ9QEwAQ

If it's a stock set up you adjust the clutch by lifting the clutch pedal up.
The instructions are in your owners manual or if you don't have it go to this Ford website to view or download it for free.

https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

CABIN NOISE IN 2000 FORD MUSTANG

If you have a way to get it off the ground (i.e. ramps) then its a snap. First, go buy the proper part, drive it up on the ramps and set the parking brake. Then look for any cables and wire harnesses that are connected to the transmission itself and disconnect them, remembering where they go. Next is to have a floor jack under the transmission to hold it while you loosen and then take the transmission mount bolts out. Lower the transmission down and change the clutch plates. Follow the same procedure in reverse and it shouldn't take you too long to have it back on the road with a new clutch done by you!

I can't find that Ford had a 3.6L in 2000 for Mustang.
Here's a link to a 3.8L
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7002

Here's a 4.6L diagram
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S8016

Ummm you don't,
the clutch has to have the transmision removed to replace, but you leave the HYDRAULIC part on
It doesn't even need djustment

I was just looking for another fuse and came across this diagram and it shows every fuse and relay and where it goes. The Fuel Pump Relay is in the O slot in the fuse box under the hood which is located near the battery. it is a 20 amp mini fuse. Hope this helps, i saved the link for future use if i need it, might be a good idea for you too. Good Luck here is the link.....
http://www.miracerros.com/mustang/2000_fuse.html

Hi pgarrity,hope this helps my friend good luck,this is simplified :)