Gear problems the bike starts alright but as sooon as i put it in first gear the engine cuts out.

Do you have the kickstand up when you put it in gear? Many bikes have a lockout on the side stand to prevent you riding away with the stand down. Kills the engine instantly when placed in gear with the stand down.

The problem is the side stand cut out switch - it allows you to start the bike to warm it up on the side stand but if you true to ride off with the side stand down the bike will cut out reminding you the stand is down.
If you bike is cutting out when putting it into gear after starting it is definitely the cut out switch - check the side stand there will be a switch around it some where close to were it bolts onto the frame.

Clutch is Not releasing! needs to be adjusted properly

Most, if not all bikes have a safety device installed which prevents the engine from being started when in gear. There is generally another which cuts the engine dead if the side stand is put down when the bike is in gear.
Hope this helps.

It might be a clutch safety switch thats been disabled ?

driveshaft or chain

hi...put kickstand up 1st befor putting in gear....as this how bigger hondas work its a safety thing so u carnt ride off with side stand down...but cuts engine if kickstand still down & then wont start as you in gear.....even if kickstand up wont start in gear!!...hope this helps

Your kickstand switch is either broken or out of position. The bike kills the engine as a safety feature if it thinks the sidestand is down and the bike is put in gear while the engine is running.

hello and welcome
it seems that you may have a faulty side stand switch. the side stand needs to be in the up position before the bike can be started off in gear. but if not the side stand contains a saftety switch that shuts the bike off when put into gear. to verify this you can check for spark when the bike is being turned over in gear with the clutch held in.
there should be two wires associated with this switch. a green, and green with white. so when the stand is up these two wires are connected, and the switch can be tested as such. thank you.

Does the bike have a sidestand switch that cuts the power if the stand is left down? If it does, disconnect it and temporarily join the ends together and try starting....