BMW R1200RT LE headlight alignment

These links show multiple fuse boxes and fuses which have something to do with daytime running light and lights.
Fuse box location and diagrams: Toyota Camry (1997-2001) - YouTube
Toyota Camry (1999 - 2000) - fuse box diagram - Auto Genius
1999 Toyota Camry Headlight Bulb Replacement, Relays and Fuses Explained - YouTube

Toyota Camry 2000 model headlight fault high beams not working xv20 Camry headlight switching off - YouTube

Toyota Camry Lights Not Working - YouTube

• 
  
• 1.
  Remove the two upper screws from the headlight housing, using a Phillips screwdriver.
  
• .
  Locate the two lower retaining nuts inside the engine compartment at the bottom of the headlight housing. Remove the nuts using a ratchet, extension and socket.
  
• Separate the turn signal and marker light assembly from the front grill. Rotate the bulb holders counterclockwise and pull them out of the assembly. Set the assembly aside.
  
• Unplug the headlight bulb connector from the bulb. Rotate the retaining ring counterclockwise one-eighth turn and remove it from the housing. Pull the headlight bulb straight back and out of the housing. Do not rotate the bulb during disassembly.
  
• Lift up on the headlight housing retaining clips to unsnap them from the headlight housing vertical adjuster studs.
  
• Locate the horizontal adjuster at the outer bottom corner of the headlight assembly inside the engine compartment. Loosen the horizontal adjuster until it is free of the adjuster nut.
  
• Remove the headlight housing from the vehicle.
  

Installation

• Install the headlight housing in the front grill.
  
• Engage the horizontal adjuster screw with the adjuster nut and screw it partially in.
  
• Snap the headlight housing clips on the vertical headlight adjuster studs.
  
• Insert the headlight bulb into the headlight housing, flat side up. Slightly rotate the headlight bulb to engage the grooves in the light with the alignment tabs in the back of the housing. Install the retaining ring on the bulb. Plug in the headlight bulb connector.
  
• Install the bulb holders in the turn signal and marker light assembly. Install the assembly in the grill. Install the two upper screws, using a Phillips screwdriver. Install the two lower retaining nuts, using a ratchet, extension and socket.
  

Headlight Aiming

• Pull the vehicle to within a few inches of a blank wall, on a flat surface. Apply two strips of tape to the wall vertically to mark the centers of the headlights. Apply a strip of tape to the wall horizontally to mark the center of the headlight height. Back the vehicle up 25 feet in a straight line.
  
• Turn the headlight low beams to the "On" position.
  
• Adjust the vertical headlight adjusters until the high-intensity zone of the light pattern is two inches below the horizontal mark on the wall.
  
• Adjust the horizontal headlight adjusters until the high-intensity zone of the light pattern is two inches to the right of the vertical headlight marks on the wall.
  

Hi mario,

Stand by the washer reservoir under the hood while someone operates the washers. The headlights must be in the on position for the sprayer to work. Attached to the reservoir will be 2 washer pumps. On pump is for the windshield washer, the other for the headlight washer. They are interchangeable for testing. The reservoir can be removed after removing the 2 black speed nuts. (use a 10mm socket and ratchet). Also make sure the grommet with screen under each pump is not full green algae. Your pump has most likely failed.

Manifold to Cylinder head (acorn nuts) tighten to 21 Nm or 15.5 Lb/Ft

Headlight relays..1 for low 1 for high..These are most time under gas tank.Might be also located on battery box