SOURCE: My brushes are not turning. We checked the gear and it is turning, but brushes aren't
Take the brushroll out and see if it turns freely just by holding the end. Also make sure that the belt isn't stretched out. Also, before putting the head on the vac, you have to pick the belt up on the "finger" that's in the head. You can verify this by looking into the circle that's cut out of the metal. When the head is affixed to the vac, then turn the belt lifter back around to the proper position and all should be well. If you still need help, you may call us at 1-866-509-1952. Thanks
SOURCE: starter motor will not work unless 12v feed put through relay
Have you checked the solenoid across the main posts i.e.connection from battery to starter,you may be hearing the solenoid clicking when you operate the starter button,but it might not be completing the circuit.
SOURCE: !983 honda magna v45 clutch not engaging
if you rebuilt your carburetors you have made a mistake when you reassembled them a carb must sprsy a fine mist of "dry" fuel into the engine intake your carbs are flooding you need to check your fuel floats , jets and, don't forget to check the power piston circuit and, balance (sync) your carbs on the bike when you're done
your chuch is fine if you did not touch it
SOURCE: mower starter pinion gear won't stay on flywheel to start it
you can actually just replace the starter bendix
SOURCE: starter works but gears seem to free spin, wont crank engine
sounds like the sprag clutch has failed. If you can see the large gear that sits behind the rotor and its turning but the rotor isnt turning the sprag clutch has failed. Very costly. usualy you would have a missed start eg not engaging every now and then before this fails all together.
290 views
Usually answered in minutes!
×