I have good pressure at both ends of the clutch cable, it feels like it is pushing the rod
SOURCE: yz 125 2001 stays in gear when clutch pulled in
Lose the Honda transmission oil. It may have swollen the cork on the friction plates. Go with 10w40 in the gearbox. Any major brand; Mobil, Shell, Quaker State, Pennzoil, etc.. Try the new oil and give the cork a week to shrink back down > if they will. You may need to put in a new set of plates.
SOURCE: yz 125 2001 stays in gear with clutch pulled in
hi m8,,this might sound stupid,, but in winter dayz and salty conditions ,cables corrode in side,,so i can start some where to help,, 1st take the cable off the handle bar,, and the clutch casin,,get a little bit of oil in a jam jar or any thing like that,,dip one end of the cable in the oil ,and keep pullin and pushing the inner cable as if u were trying to draw oil up threw the inside of the cable ,, turn cable the other end and repeat,, try that 1st m8,, still have probs come bk, and il go threw the next step,,
SOURCE: Clutch wont engage after kickstarter shaft installation.
The clutch lever must have been pushed in when i tried to install the push rod the first time so the push rod didn't get pushed in all the way.
SOURCE: Clutch push rod will not depress to engage
go to this http://www.cmsnl.com/yamaha-rt1-19701971_model8356/partslist/A-09.html and then click on "view big image", this will give you a diagram of the clutch etc,, the adjustment (No. 26) may need looking at, or (No.11,12,) have broken.Basically you turn 26 in (clockwise) untill you feel light resistance then back off 1/2 turn (been years since i worked on one of these!) this should give you freeplay, have you just got the bike?, and do you think it has been stripped lately(ie the clutch). PS I am not affiliated with the web site i offered above, just a handy reference for you maybe? cheers
SOURCE: replaced clutch in 3000GT, all new parts, plate,
Are you sure the clutch disc is installed in the correct direction?
Admittedly, I haven't seen the clutch disc for a Mitsubishi 3000GT, but I have seen my share in many makes of vehicles.
The clutch disc may be one of those that will install in either direction. Some clutch discs are made so that the inner hub with springs, can be installed towards the crankshaft, or towards the tranny.
73 views
Usually answered in minutes!
×