Question about 1995 kawasaki ZX-6R Ninja

1 Answer

How to fix the timing on my 1989 ninja 600r? My 89 Ninja 600r is out of time and won't crank.

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • kawasaki Master
  • 58,763 Answers

Hi, Anonymous and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the choke.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Quick disconnect check ball stuck.
14. Compression below 75 PSI.
15. A stuck-bent-burnt valve.
16. Improper valve clearance (too tight)
17. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
18. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
19. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
20. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections are loose or connected to the wrong cylinders.
21. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
22. Faulty neutral, clutch, kickstand safety switch.
23. Faulty fuel pump or fuse or relay.
24. Faulty or corroded run/stop switch.
25. Tilt sensor needs a reset.
26. Security system not disarming alarm needs a reset.
27. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.kawasakimotorcycle.org/forum/mechanics-corner/79264-1987-ninja-600r-timing-issues.html
https://www.youtube.com/watch?v=MgEBi6Cb3kE
https://www.manualslib.com/manual/1101849/Kawasaki-1985-Zx600.html
https://www.partsfish.com/page/oem-parts-for-kawasaki
http://mybikemanuals.com/kawasaki/

Posted on Sep 23, 2019

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

tombones

  • 3567 Answers

SOURCE: which plug wires go to which cylinder on a 1986

This should help. Pleasse rate this answer.

f5bbe47.png

Posted on Aug 04, 2009

Anonymous

  • 9 Answers

SOURCE: will 89 ninja engine fit 99 ninja

no. and the 99 made bike of the year. find one on ebay and put it back. that motor is awsome!

Posted on Aug 25, 2009

ollie reece

ollie reece-jones

  • 1167 Answers

SOURCE: how to clean carbs on a 92 ninja 600R ?

TRY THIS SITE BUDDY http://knol.google.com/k/evan/how-to-clean-a-motorcycle-carburetor/1cxrwhqe214sz/2#

Posted on Sep 08, 2009

SOURCE: what size spark plug go in a ninja 96 zx 600r

NGK CR9E

Posted on Feb 02, 2011

PAUL EDWARDS

  • 738 Answers

SOURCE: On a 1986 kawasaki ninja

This may differ from model to model, as a rough guide with standard jetting, 2.5 to 3 turns out, screw the air corrector screw home (in) all the way until it stops using no force, as soon as you feel it is home stop, then unscrew the screw 5 half turns which equates to 2.5 full turns as a base setting, any furter addjustments should be done in half turn increments in or out untill the bike runs at its best

Posted on Apr 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the battery fusable link location for a 1989 gpx kawasaki


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Kawasaki, despair not, for a mere $10 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
1989 kawasaki gpx 750 fuse box location Google Search
Kawasaki GPZ 600R GPX 600R Ninja 600R RX GPX 750R Ninja 750R Download...
OEM Parts for Kawasaki
Kawasaki GPX250R 87 Service Manual pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Mar 06, 2017 | 1989 kawasaki GPX 750 R

1 Answer

Where is the fuel pump on 1986 Kawasaki Ninja 600r


Hi, Richard for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Kawasaki, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
1986 Kawasaki Ninja 600r fuel pump location Google Search
Help 1993 Kawasaki Ninja 600R ZX600C
Kawasaki Ninja ZX 6R Service Manual
OEM Parts for Kawasaki
Kawasaki Ninja ZX 6R Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Jan 21, 2017 | kawasaki ZX-6R Ninja Motorcycles

1 Answer

I put a 94 ninja 600r engine in my 86 ninja. nearly twice the hp now but it runs to hot.i need to know the coolant capacity of a 1994 ninja 600r


try putting the radiator of the 94 motor in place of the 86 radiator or sourcing a radiator with more cores in it

Nov 15, 2015 | kawasaki Motorcycles

1 Answer

What is coolant capacity for 1994 ninja 600r


Hi James, I am sorry you can't find the first and best tool you ever bought for your Kawasaki but despair not for a mere $10 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
https://www.tradebit.com/filesharing.php/search/0/1994+kawasaki+ninja+600r

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Nov 15, 2015 | kawasaki Motorcycles

1 Answer

1987 Kawasaki GPX 750 R how to sync carburetors


Hi, Anonymous for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere $15 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
How to Carb Synching
How to sync carbs on motorcycle
Kawasaki GPZ 600R GPX 600R Ninja 600R RX GPX 750R Ninja 750R Download... $15
OEM Parts for Kawasaki
http://mybikemanuals.com/kawasaki

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Jan 18, 2014 | 1987 kawasaki GPX 750 R

1 Answer

I want to turn my 89 ninja 600r into a streetfighter. Any ideas for rear fender and a gauge substitute? Also what modifications are best for the seat?


street fight kits are available all over the internet. it really comes down to what you like as the look in the end.

Sep 26, 2013 | Motorcycles

1 Answer

1989 Kawasaki Ninja 600R wiring diagram


Hi, Tyler for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
1989 Kawasaki Ninja 600R wiring diagram Google Search
Kawasaki Motorcycle Wiring Diagrams
Kawasaki 1985 ZX600 Service And Repair Manual
OEM Parts for Kawasaki
1993 Kawasaki Ninja 600R Owner Manual

Jul 31, 2013 | kawasaki ZX-6R Ninja Motorcycles

1 Answer

89 kawasaki ninja 250 crank no start


ok i have one and i just fixed mine you need to drain the fuel from bottom of carbs and drain the tank also. then replace the spark plugs once you do that add new fuel in tank and drain the carbs again unitil good fule start runing out then shut them off. aftre that make sure there are two line connected to the petcock from the carb. spray soem starting fluid in the air box and chock it boom it will start. if it has spark.

chris

Jul 12, 2009 | 2008 kawasaki Ninja 250R

Not finding what you are looking for?
1995 kawasaki ZX-6R Ninja Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5954 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

ROB

Level 3 Expert

858 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...