Hoses to gas tank from carbs i need a diagram

On the web
images for 1983 suzuki rm 250 hose connection

Right you have three hoses, there are two holes in the tank unit, the smaller of the two holes ( too the left hand side as you look down on top) this is the main fuel hose which has the fuel filter on the end in the tank, this then fits to the right hand connection on the carb, there is then a short hose which connects to the carb on the left hand side, and then goes to the shorter of the two connections on the back of the primer ( suction side ) there is then a hose from the longer connection on the primer( pressure side ) back to the hole to the right hand side of the tank , so to recap the primer pulss fuel from the carb, into the primer bulb, and dumps back to the tank.

There should be three hoses, the hose from the tank with the filter on, goes to the fuel inlet on the carb, this is the connection closest to the pump cover held with one screw, the other pipe from the carb closest to the metering side, goes to the short connection on the back of the primer, this is the suction side, the hose from the longest conection on the primer, the pressure side, returns to the tank.
just remember the primer pulls fuel from the carb, and dumps it back into the tank, not the other way round,

There is no diagram that shows this, however i can tell you where they go, the fuel hose from the tank with the fuel filter on goes to the fuel inlet on the carb, the nozzel nearest to the pump side of the carb ( cover held with one screw ) the pipe from the carb nearest to the metering side ( cover held with four screws ) goes to the suction side of the primer ( short nozzel on primer ) there is then a pipe from the pressure side of the primer ( longest nozzel on the primer ) back to the tank ( just pushed into the top of the tank ), just remenber the primer pulls fuel from the carb, and dumps it back into the tank.

there should only 2 lines from the fuel tap, one for fuel, and the other for vacume, the smaller diameter hose is the vacume, and the larger hose is fuel. fuel hose will go to carby, and the vacume hose to the carby inlet manifold.

need diagram to replace fan belt on suzuki vitara xl 7 2ltr diesel 2004

I am not certain exactly what bike you have so consider the diagram below as generic. Chances are the float needle is sticking open a bit. A bit of trash may be stopping it from closing fully. The overflow hose is where any "excess" gas is dumped. This hose vents to the open air. Be sure to turn off the gas valve (petcock) at the bottom side of the tank when bike is not in use. Please rate my answer. Thanks!

Diagram not needed? Start by taking apart the cover(s) that surround the carb, there should be a least 4 bolts holding your cover assembly together. Once the cover is off just replace hose with one the same length maybe a little longer.

Your carb has two gas line fittings, an inlet and outlet. The third line from the gas tank fits on the inlet fitting of the carb.

the bottom fuel line that goes to carb lower port also goes to the fuel tank look inside fuel tank threw gas cap hole to find the fuel filter hose is picking up the fuel and bringing the gas to the lower fuel port into carb (the upper from carb goes to prime or return to tank)